Re: [hylafax-users] i536ep issues (continuation)

[Bojan Stojanovic <bojan.stojanovic@xxxxxxxxxxxxx>]

OK
AT+GCI=C1
ERROR

I put my ear beside modem but I don't hear it buzzing, even when I call
from internal line modem say RING but it don't buzz. I even had speakers
connected to it...

My extension rings two times shortly when called from ext. line, and one
long when it's called internaly. In use with HylaFAX 536ep answers only
to internal calls (is able to receive faxes). Our PBX here is Ericsson
BussinesPhone 250.

On Fri, 2006-06-02 at 16:03 +0200, Philippe Vouters wrote:
> Bojan,
> 
> It is my fault. I always confuse between CGI (ERROR) and GCI, so the
> correct command is AT+GCI=C1 (C1 for Yugoslavia. Have a look at
> http://www.katpatuka.org/pub/doc/t.35.html)
> 
> As for minicom being quiet when dialing from an external line, do you
> hear any sound from the 536EP integrated buzzer ? Perhaps the short
> beeps which come from the PBX are too short to be detected as an actual
> RING. How does your internal extension ring when dialed by an external
> number ? Short or long beeps ?
> Philippe
> Le vendredi 02 juin 2006 à 15:32 +0200, Bojan Stojanovic a écrit :
> > We're gone offtopic so I changed name of a subject,
> > 
> > Minicom output:
> > OK
> > 
> > RING - dialed from internal ext.
> > AT+CGI=381
> > ERROR
> > AT+CGI=<381>
> > ERROR
> > 
> > When dialed from external number minicom is always quiet.
> > 
> > What we have here is PBX which is authorative for +381112040xxx domain.
> > HylaFAX here is etx. 962 (+381112040962). Ring patterns for calls which
> > come from the outside world and from the internal ext. xxx are
> > different. When I dial 962 (hylafax) from 936 (my ext.) that is a one
> > long beep on ext. device (and minicom says RING), but when I call 962
> > from let's say +38163306578 that are the 2 short beeps for ext. device
> > (and minicom is quiet). That is the way PBX is set and it can't be
> > changed. But when I use any external serial modem it recognies and
> > minicom says RING for any type of call, from internal or external.
> > 
> > Fact is that with i536ep modem I can receive faxes sent only from
> > company. B)
> > 
> > 536ep is good. some SmartLink internal PCI SW modems could only dial
> > out, they were quiet in minicom from either internal or external call.
> > 
> > On Fri, 2006-06-02 at 14:41 +0200, Philippe Vouters wrote:
> > > Bojan,
> > > 
> > > Looking at your AT commands, it seems you miss the AT+CGI=<your country
> > > code>. I do not know if this can also help you, but people from Serbia
> > > had to ATX3 to dial their respective ISP.
> > > 
> > > I can't say why there is no RING indicator when dialing though the PBX.
> > > Are you sure you have an analog line (ATDT) and not a pulse line (ADTP)
> > > when dialing through the PBX ? As the Intel 536EP is equipped with a
> > > integrated buzzer, when dialing the 536EP modem number, do you hear
> > > rings, some noise or absolutely nothing ?
> > > 
> > > Does it happen that if you remove /dev/536ep from the list of hylafax
> > > recognized modems and you use "$ efax -v ewinchmart", does efax
> > > indicates that a RING is detected ? Test it when dialing from locally
> > > and from remotely to ensure you actually go through the PBX equipment.
> > > 
> > > Hoping this can help you.
> > > Regards,
> > > Philippe Vouters (Fontainebleau/France)
> > > 
> > > Le vendredi 02 juin 2006 à 10:28 +0200, Bojan Stojanovic a écrit :
> > > > It works thanks to Philippe Vouters who modified Intel's driver so it
> > > > now compiles under FC4, FC5, etc.
> > > > http://linmodems.technion.ac.il/packages/Intel/Philippe.Vouters
> > > > 
> > > > Only thing is that I "can't" receive faxes as I described before:
> > > > >"When I do a little testing in minicom, when I'm dialing Hylafax (from
> > > > >960 to 962 for example)from internal line it says RING, but when I try
> > > > >the same from any external line to Hylafax (2040962) minicom says
> > > > >nothing."
> > > > Ring pattern is different for external calls and our PBX admin can't do
> > > > anything about it. External serial modems recognise this ring pattern
> > > > fine but not 536ep.
> > > > 
> > > > Here is it's configuration (config.536ep):
> > > > 
> > > > CountryCode:            381
> > > > AreaCode:               11
> > > > FAXNumber:              +xxx.xx.xxxx.962
> > > > LongDistancePrefix:     0
> > > > InternationalPrefix:    99
> > > > DialStringRules:        etc/dialrules
> > > > ServerTracing:          1
> > > > SessionTracing:         11
> > > > RecvFileMode:           0600
> > > > LogFileMode:            0600
> > > > DeviceMode:             0600
> > > > RingsBeforeAnswer:      0
> > > > SpeakerVolume:          off
> > > > GettyArgs:              "-h %l dx_%s"
> > > > LocalIdentifier:        "Network Co."
> > > > TagLineFont:            etc/lutRS18.pcf
> > > > TagLineFormat:          "%%l|%c|Page %%P of %%T"
> > > > PercentGoodLines:       0
> > > > MaxConsecutiveBadLines: 100
> > > > MaxRecvPages:           25
> > > > ModemType:              Class1
> > > > ModemDialCmd:           ATDT0%s
> > > > Class1Cmd:              AT+FCLASS=1
> > > > Class1PPMWaitCmd:       AT+FTS=7
> > > > Class1TCFWaitCmd:       AT+FTS=7
> > > > Class1EOPWaitCmd:       AT+FTS=9
> > > > Class1SwitchingCmd:     AT+FRS=7
> > > > Class1TrainingRecovery: 1500
> > > > Class1RecvAbortOK:      200
> > > > Class1FrameOverhead:    4
> > > > Class1RecvIdentTimer:   40000
> > > > Class1TCFMaxNonZero:    10
> > > > Class1TCFMinRun:        1000
> > > > 
> > > > I don't know 'bout receivers fax machine i picked their fax No. randomly
> > > > by googling and sent them a Google's home page as FAX. Receiver was some
> > > > mathematic universities's library from Novi Sad (BTW I reccomend to you
> > > > Novi Sad's http://eng.exitfest.org as a good summer time fest'). :-) 
> > > > 
> > > > They received a fax from the 3'rd try:
> > > > 
> > > > Your facsimile job to 021455662 was completed successfully.
> > > > 
> > > >             Pages: 1
> > > >          Receiver: 003812155662
> > > >           Quality: Fine
> > > >        Page Width: 0 (mm)
> > > >       Page Length: 0 (mm)
> > > >       Signal Rate: 9600 bit/s
> > > >       Data Format: 2-D MMR
> > > >  Remote Equipment: Panasonic 
> > > >    Remote Station: PMF NOVI SAD 
> > > >           Dialogs: 3 (exchanges with remote device)
> > > >             Calls: 3 (total phone calls placed)
> > > >    Submitted From: 10.1.1.10
> > > >             JobID: 10
> > > >           GroupID: 10
> > > >            CommID: c000000011
> > > > 
> > > > Processing time was 0:55.
> > > > 
> > > > Log of this job is attached.
> > > > 
> > > > Best regards,
> > > Philippe Vouters (Fontainebleau/France)
> > > http://linmodems.technion.ac.il/packages/Intel/
> > > 
> > > 
> Philippe Vouters (Fontainebleau/France)
> http://linmodems.technion.ac.il/packages/Intel/
> 
> 
-- 
Bojan Stojanović
Network Co. A.D.
sistem administrator
tel: +381 11 2040 936



____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*