Re: [hylafax-users] MODEM Command error

[Matt <mathfretwell@xxxxxxxxxxxxxxxx>]

> Hi Sebastian
> 
> Faxgetty is not running as I am using a send only setup.
> 
> I have been browsing through the archives, and I have seen some of the 
> solutions given to errors that I am getting are to setup the modem as a 
> class1 modem. I have set up my 'U.S. ROBOTICS 56K FAX EXT REV. 11.11.13 
> 5601' modem as a class 2.0, could this have anything to do with it....
> If I run cu -l ttyS0 and then at+fclass=?
> I get 0,1,2.0 ??? so I just assumed that 2.0 would be fine, what is
> best?
> 

 The general consensus tends to be that the USR class 2* firmware is ,
ahem, buggy. Setting it up a a class 1* will usually give better results.
 Obviously, it is to some degree a case of "suck it and see".

Matt


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*