Re: [hylafax-users] MODEM Command error

[Clinton Bosch <clinton@xxxxxxxxxxxxx>]

Hi Sebastian

Faxgetty is not running as I am using a send only setup.

I have been browsing through the archives, and I have seen some of the 
solutions given to errors that I am getting are to setup the modem as a 
class1 modem. I have set up my 'U.S. ROBOTICS 56K FAX EXT REV. 11.11.13 
5601' modem as a class 2.0, could this have anything to do with it....
If I run cu -l ttyS0 and then at+fclass=?
I get 0,1,2.0 ??? so I just assumed that 2.0 would be fine, what is best?

Sebastian Flothow wrote:

> Am 7. Jul 2004 um 16:28 Uhr schrieb Clinton Bosch:
>
> > And from then on ALL subsequent faxes fail with the same error. I 
> > have found that by running the command, it seems to come right again: 
> > /usr/local/sbin/faxmodem -c '(0,1),(0-5),(0-2),(0-2),0,0,0,(0-7)' ttyS0
> >
> > But why do I need to "Remind" hylafax about its modem all the time???
>
>
> Is faxgetty running? It should monitor the modem for any interesting 
> events and notify the main (queueing) daemon.
>
>
> Sebastian

--
Clinton Bosch - Hemisphere Technologies
JDO Genie - High performance JDO for JDBC
http://www.hemtech.co.za
Tel +27 21 670 3940 - Fax +27 21 670 3979
Cell +27 82 805 9479


____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*