[hylafax-users] T.30 T2 timeout, expected page not received

To: "'Hylafax list'" <hylafax-users@xxxxxxxxxxx>
Subject: [hylafax-users] T.30 T2 timeout, expected page not received
From: "Andras Kende" <andras@xxxxxxxxx>
Date: Tue, 20 Apr 2004 11:59:01 -0500

Recently installed Hylafax 4.1.8 on FreeBSD 5.2.1 with 1 USR 56K External
modem.

Everything good except there is many of the same:

'T.30 T2 timeout, expected page not received' 

Maybe 10-15% of incoming faxes..

Searched google but didn't find a definitive answer.

Is a quick hack command available,
or the problem related to the USR modem ?? 

Should I just get a Multitech MT5634ZBA-V-V92-NAM ?


Thanks,

Andras Kende
andras@xxxxxxxxx




recvq/fax00074.tif (\\faxserver\fax\fax00074.tif):
    Sender: 248 553 0100
     Pages: 3
   Quality: Normal
      Page: North American Letter
  Received: 2004:04:20 09:22:30
TimeToRecv: 0:43
SignalRate: 14400 bit/s
DataFormat: 2-D MR
ReceivedOn: cuaa0

The full document was not received because:

    T.30 T2 timeout, expected page not received

    ---- Transcript of session follows ----

Apr 20 09:22:14.61: [  539]: SESSION BEGIN 00000074 13105154968 Apr 20
09:22:14.61: [  539]: HylaFAX (tm) Version 4.1.8 Apr 20 09:22:14.61: [
539]: <-- [4:ATA\r] Apr 20 09:22:20.15: [  539]: --> [7:CONNECT] Apr 20
09:22:20.15: [  539]: ANSWER: FAX CONNECTION  DEVICE '/dev/cuaa0'
Apr 20 09:22:20.15: [  539]: RECV FAX: begin Apr 20 09:22:20.18: [  539]:
--> [7:CONNECT] Apr 20 09:22:22.13: [  539]: --> [2:OK] Apr 20 09:22:22.13:
[  539]: <-- [9:AT+FRH=3\r] Apr 20 09:22:23.01: [  539]: --> [7:CONNECT] Apr
20 09:22:24.31: [  539]: --> [2:OK] Apr 20 09:22:24.31: [  539]: REMOTE TSI
"248 553 0100"
Apr 20 09:22:24.31: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:22:24.33: [  539]:
--> [7:CONNECT] Apr 20 09:22:24.66: [  539]: --> [2:OK] Apr 20 09:22:24.66:
[  539]: REMOTE wants 14400 bit/s Apr 20 09:22:24.66: [  539]: REMOTE wants
page width 1728 pixels in 215 mm Apr 20 09:22:24.66: [  539]: REMOTE wants
unlimited page length Apr 20 09:22:24.66: [  539]: REMOTE wants 3.85 line/mm
Apr 20 09:22:24.66: [  539]: REMOTE wants 2-D MR Apr 20 09:22:24.66: [
539]: RECV training at v.17 14400 bit/s Apr 20 09:22:24.66: [  539]: <--
[11:AT+FRM=145\r] Apr 20 09:22:26.47: [  539]: --> [7:CONNECT] Apr 20
09:22:28.04: [  539]: RECV: TCF 2811 bytes, 3% non-zero, 2701 zero-run Apr
20 09:22:28.04: [  539]: --> [10:NO CARRIER] Apr 20 09:22:28.04: [  539]:
DELAY 75 ms Apr 20 09:22:28.12: [  539]: TRAINING succeeded Apr 20
09:22:28.12: [  539]: <-- [9:AT+FTH=3\r] Apr 20 09:22:28.31: [  539]: -->
[7:CONNECT] Apr 20 09:22:29.49: [  539]: --> [2:OK] Apr 20 09:22:29.49: [
539]: <-- [11:AT+FRM=146\r] Apr 20 09:22:30.26: [  539]: --> [7:CONNECT] Apr
20 09:22:30.26: [  539]: RECV: begin page Apr 20 09:22:53.36: [  539]: RECV:
1091 total lines, 3 bad lines, 3 consecutive bad lines Apr 20 09:22:53.36: [
539]: RECV: end page Apr 20 09:22:53.36: [  539]: --> [10:NO CARRIER] Apr 20
09:22:53.36: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:22:53.76: [  539]: -->
[7:CONNECT] Apr 20 09:22:54.79: [  539]: --> [2:OK] Apr 20 09:22:54.79: [
539]: RECV recv MPS (more pages, same document) Apr 20 09:22:54.79: [  539]:
<-- [9:AT+FRS=7\r] Apr 20 09:22:55.90: [  539]: --> [2:OK] Apr 20
09:22:55.90: [  539]: <-- [9:AT+FTH=3\r] Apr 20 09:22:56.09: [  539]: -->
[7:CONNECT] Apr 20 09:22:56.09: [  539]: RECV send MCF (message
confirmation) Apr 20 09:22:56.09: [  539]: RECV FAX (00000074): from 248 553
0100, page 1 in 0:28, INF, 3.85 line/mm, 2-D MR, 14400 bit/s Apr 20
09:22:57.27: [  539]: --> [2:OK] Apr 20 09:22:57.27: [  539]: <--
[11:AT+FRM=146\r] Apr 20 09:22:58.04: [  539]: --> [7:CONNECT] Apr 20
09:22:58.04: [  539]: RECV: begin page Apr 20 09:23:11.43: [  539]: RECV:
1111 total lines, 0 bad lines, 1 consecutive bad lines Apr 20 09:23:11.43: [
539]: RECV: end page Apr 20 09:23:11.43: [  539]: --> [10:NO CARRIER] Apr 20
09:23:11.43: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:23:11.80: [  539]: -->
[7:CONNECT] Apr 20 09:23:12.88: [  539]: --> [2:OK] Apr 20 09:23:12.88: [
539]: RECV recv MPS (more pages, same document) Apr 20 09:23:12.88: [  539]:
<-- [9:AT+FRS=7\r] Apr 20 09:23:13.65: [  539]: --> [2:OK] Apr 20
09:23:13.65: [  539]: <-- [9:AT+FTH=3\r] Apr 20 09:23:13.84: [  539]: -->
[7:CONNECT] Apr 20 09:23:13.84: [  539]: RECV send MCF (message
confirmation) Apr 20 09:23:13.84: [  539]: RECV FAX (00000074): from 248 553
0100, page 2 in 0:17, INF, 3.85 line/mm, 2-D MR, 14400 bit/s Apr 20
09:23:15.02: [  539]: --> [2:OK] Apr 20 09:23:15.02: [  539]: <--
[11:AT+FRM=146\r] Apr 20 09:23:15.80: [  539]: --> [7:CONNECT] Apr 20
09:23:15.80: [  539]: RECV: begin page Apr 20 09:23:16.84: [  539]: RECV: 3
total lines, 1 bad lines, 1 consecutive bad lines Apr 20 09:23:16.84: [
539]: RECV: REJECT page quality, 66% good lines (95% required) Apr 20
09:23:16.84: [  539]: RECV: end page Apr 20 09:23:16.84: [  539]: --> [10:NO
CARRIER] Apr 20 09:23:16.84: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:23:19.67:
[  539]: --> [7:CONNECT] Apr 20 09:23:20.39: [  539]: --> [5:ERROR] Apr 20
09:23:20.39: [  539]: MODEM Command error Apr 20 09:23:20.39: [  539]: FCS
error Apr 20 09:23:20.39: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:23:20.41: [
539]: --> [7:CONNECT] Apr 20 09:23:21.22: [  539]: --> [5:ERROR] Apr 20
09:23:21.22: [  539]: MODEM Command error Apr 20 09:23:21.22: [  539]: FCS
error Apr 20 09:23:21.22: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:23:21.23: [
539]: --> [7:CONNECT] Apr 20 09:23:22.09: [  539]: --> [5:ERROR] Apr 20
09:23:22.09: [  539]: MODEM Command error Apr 20 09:23:22.09: [  539]: FCS
error Apr 20 09:23:22.09: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:23:22.10: [
539]: --> [7:CONNECT] Apr 20 09:23:26.98: [  539]: --> [5:ERROR] Apr 20
09:23:26.98: [  539]: MODEM Command error Apr 20 09:23:26.98: [  539]: FCS
error Apr 20 09:23:26.98: [  539]: <-- [9:AT+FRH=3\r] Apr 20 09:23:27.00: [
539]: --> [7:CONNECT] Apr 20 09:23:31.98: [  539]: --> [5:ERROR] Apr 20
09:23:31.98: [  539]: MODEM Command error Apr 20 09:23:31.98: [  539]: FCS
error Apr 20 09:23:31.98: [  539]: RECV FAX (00000074): recvq/fax00074.tif
from 248 553 0100, route to <unspecified>, 2 pages in 1:11 Apr 20
09:23:31.98: [  539]: RECV FAX: T.30 T2 timeout, expected page not received
Apr 20 09:23:31.98: [  539]: <-- [9:AT+FTH=3\r] Apr 20 09:23:32.17: [  539]:
--> [7:CONNECT] Apr 20 09:23:33.35: [  539]: --> [2:OK] Apr 20 09:23:33.35:
[  539]: RECV FAX (00000074): session with 248 553 0100 terminated
abnormally: T.30 T2 timeout, expected page not received Apr 20 09:23:33.35:
[  539]: RECV FAX: bin/faxrcvd "recvq/fax00074.tif" "cuaa0" "00000074" "T.30
T2 timeout, expected page not received" "" ""





____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*

Follow-Ups:
- Re: [hylafax-users] T.30 T2 timeout, expected page not received
  - From: Chris Jones
- Re: [hylafax-users] T.30 T2 timeout, expected page not received
  - From: Lee Howard

Prev by Date: Re: [hylafax-users] Hylafax installation problems.
Next by Date: [hylafax-users] supported multi modem cards
Previous by thread: Re: [hylafax-users] email notification and clientmqueue permissions
Next by thread: Re: [hylafax-users] T.30 T2 timeout, expected page not received
Index(es):
- Main
- Thread

Report any problems to webmaster@hylafax.org

HylaFAX is a trademark of Silicon Graphics Corporation.
Internet connectivity for hylafax.org is provided by:
VirtuALL Private Host Services