Re: flexfax: 4.0pl2 and Phase B error

[Shuvam Misra <shuvam@spacenetindia.com>]

| >I seem to remember there was issued some mails from people having
| >phase B errors after upgradeing to 4.0pl2. Unfortunately I haven't
| >saved any of these and now I am in the position that since upgradeing
| >to 4.0pl2 all outgoing faxes encounters Unspecified Transmit Phase B 
| >errors where there previously there where none.
| 
| Try recompiling the whole pack disabling the Fine resolution in the config (p
| -- ut it on normal 98dpi) and use your modembased config to use the fine res.

Is this a general observation. I too am using a binary distribution of
4.0pl2, and I would prefer not to have to recompile.

Shuvam