Re: [hylafax-users] Direct Inward Dial based routing with FaxDispatch

["Suraj Jadhav" <sunracesuraj@xxxxxxxxxxxxxx>]

  This sounds great...let me work on this and get back to you....


On Sun, 21 May 2006 Aaron Stanford wrote :
>Suraj,
>
>Here's a partial dump of my config.ttySX and FaxDispatch to use as templates:
>
>config:
>
>ModemType:              Class2.1
>ModemRate:              57600          # for V.34 faxing
>ModemNoFlowCmd:        AT&K0
>ModemSoftFlowCmd:      AT&K4
>ModemHardFlowCmd:      AT&K3
>
>Class2APCmd:            AT+FAP=1,1,1
>Class2BUGCmd:          AT+FBU=0        # early firmware is buggy
>Class2SendRTC:          yes
>Class2UseHex:          yes
>
># Some firmwares do not report copy quality correction, although it
># is present and cannot be disabled.  Thus modem-based CQ must be used.
>Class2CQQueryCmd:      "!(00-02),(00-02)"
>Class2CQCmd:            AT+FCQ=1,0
>
># versions that respond to AT+FFC=? with non-zero data support RTFCC
>Class2RTFCC:            yes
>
># unfortunately, HylaFAX can't currently send or receive in color
># Also, the modem's extended resolution support is buggy
>ModemAnswerCmd:        AT+FCC=1,,,,0;A
>ModemDialCmd:          AT+FCC=1,,,,0;DT%s
>
># If your modem supports ECM you may want to do something like this
>Class2Cmd:              AT+FCLASS=2.1;+FRY=4
>
># Or with the MT5634ZBA-DID you'll probably need something like...
>ModemReadyCmds: AT*DS1*DD0*DF1*DN3*DP1  # enable DTMF-DID, wink-start, 3 digits
>CallIDPattern:  "DTMF"          # format of AT*DF1
>CallIDAnswerLength:    3              # three DTMF-DID digits then ATA
>
>FaxDispatch:
>
>case "$CALLID1" in
>906) SENDTO=djohnson@xxxxxxxxxxx; FILETYPE=pdf;;
>905) SENDTO=aaron@xxxxxxxxxx; FILETYPE=pdf;;
>900) SENDTO=jellinger@xxxxxxxxxxx; FILETYPE=pdf;;
>902) SENDTO=areid@xxxxxxxxxxx; FILETYPE=pdf;;
>904) SENDTO=bclute@xxxxxxxxxxx; FILETYPE=pdf;;
>903) SENDTO=jbuckman@xxxxxxxxxxx; FILETYPE=pdf;;
>901) SENDTO=khardy@xxxxxxxxxxx; FILETYPE=pdf;;
>esac
>
>Hope this helps,
>Aaron
>
>____________________ HylaFAX(tm) Users Mailing List _______________________
>  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
>On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
>  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*
>

Thanks & Regards
Suraj Jadhav