[hylafax-users] Fw: facsimile not received (on 9600)

["Tjardick van der Kraan" <tjardick@xxxxxxxxxxxxxxx>]

Hi Everyone,

We tend to get messages like these pop up when the remote fax is on 9600,
other speed (newer) faxes seem to be just fine, any ideas ?

Modem is a Multitech MT5634  ZPX-PCI

Kind regards,

Tjardick

----- Original Message ----- 
From: "The HylaFAX Receive Agent"
Sent: Tuesday, October 07, 2003 5:33 PM
Subject: facsimile not received


> An attempt to receive facsimile on ttyS4 failed because:
>
>     T.30 T2 timeout, expected page not received
>
>     ---- Transcript of session follows ----
>
> Oct 07 16:32:40.96: [31556]: SESSION BEGIN 00000549 4408715042930
> Oct 07 16:32:40.97: [31556]: HylaFAX (tm) Version 4.1.6
> Oct 07 16:32:40.97: [31556]: MODEM set XON/XOFF/FLUSH: input ignored,
output disabled
> Oct 07 16:32:40.97: [31556]: <-- [4:ATA\r]
> Oct 07 16:32:47.14: [31556]: --> [7:CONNECT]
> Oct 07 16:32:47.14: [31556]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyS4'
> Oct 07 16:32:47.14: [31556]: STATE CHANGE: ANSWERING -> RECEIVING
> Oct 07 16:32:47.14: [31556]: MODEM input buffering enabled
> Oct 07 16:32:47.14: [31556]: RECV FAX: begin
> Oct 07 16:32:47.41: [31556]: MODEM input buffering disabled
> Oct 07 16:32:47.44: [31556]: <-- HDLC<23:FF C0 02 A6 2E 96 B6 96 36 04 E6
76 96 76 A6 26 4E 86 E2 A6 76 F6 E2>
> Oct 07 16:32:47.47: [31556]: --> [7:CONNECT]
> Oct 07 16:32:47.47: [31556]: <-- HDLC<10:FF C8 01 00 77 5F 01 79 03 C0>
> Oct 07 16:32:48.67: [31556]: --> [2:OK]
> Oct 07 16:32:48.68: [31556]: <-- [9:AT+FRH=3\r]
> Oct 07 16:32:49.11: [31556]: --> [7:CONNECT]
> Oct 07 16:32:50.71: [31556]: --> HDLC<25:FF C0 C2 8C EC 9C AC 04 AC 1C AC
04 8C 4C 8C 0C 04 04 04 04 04 04 04 99 28>
> Oct 07 16:32:50.71: [31556]: --> [2:OK]
> Oct 07 16:32:50.71: [31556]: REMOTE TSI "0121 585 5971"
> Oct 07 16:32:50.71: [31556]: <-- [9:AT+FRH=3\r]
> Oct 07 16:32:50.72: [31556]: --> [7:CONNECT]
> Oct 07 16:32:50.98: [31556]: --> HDLC<9:FF C8 C1 00 61 15 00 D1 06>
> Oct 07 16:32:50.98: [31556]: --> [2:OK]
> Oct 07 16:32:51.01: [31556]: REMOTE wants 9600 bit/s
> Oct 07 16:32:51.01: [31556]: REMOTE wants page width 1728 pixels in 215 mm
> Oct 07 16:32:51.01: [31556]: REMOTE wants unlimited page length
> Oct 07 16:32:51.01: [31556]: REMOTE wants 3.85 line/mm
> Oct 07 16:32:51.01: [31556]: REMOTE wants 2-D MR
> Oct 07 16:32:51.01: [31556]: <-- [9:AT+FRH=3\r]
> Oct 07 16:32:51.01: [31556]: --> [7:CONNECT]
> Oct 07 16:32:51.02: [31556]: --> [10:NO CARRIER]
> Oct 07 16:32:51.02: [31556]: RECV training at v.29 9600 bit/s
> Oct 07 16:32:51.02: [31556]: MODEM set XON/XOFF/DRAIN: input ignored,
output generated
> Oct 07 16:32:51.02: [31556]: <-- [10:AT+FRM=96\r]
> Oct 07 16:32:51.35: [31556]: --> [7:CONNECT]
> Oct 07 16:32:52.95: [31556]: MODEM set XON/XOFF/DRAIN: input ignored,
output disabled
> Oct 07 16:32:52.95: [31556]: RECV: TCF 1920 bytes, 0% non-zero, 1906
zero-run
> Oct 07 16:32:52.95: [31556]: --> [10:NO CARRIER]
> Oct 07 16:32:52.95: [31556]: DELAY 75 ms
> Oct 07 16:32:53.03: [31556]: TRAINING succeeded
> Oct 07 16:32:53.03: [31556]: <-- [9:AT+FTH=3\r]
> Oct 07 16:32:53.89: [31556]: --> [7:CONNECT]
> Oct 07 16:32:53.89: [31556]: <-- HDLC<3:FF C8 21>
> Oct 07 16:32:54.21: [31556]: --> [2:OK]
> Oct 07 16:32:54.21: [31556]: MODEM input buffering enabled
> Oct 07 16:32:54.21: [31556]: MODEM set XON/XOFF/FLUSH: input ignored,
output generated
> Oct 07 16:32:54.21: [31556]: <-- [9:AT+FRS=1\r]
> Oct 07 16:32:54.33: [31556]: --> [2:OK]
> Oct 07 16:32:54.33: [31556]: <-- [10:AT+FRM=96\r]
> Oct 07 16:33:01.33: [31556]: MODEM TIMEOUT: reading line from modem
> Oct 07 16:33:01.33: [31556]: MODEM set XON/XOFF/DRAIN: input ignored,
output disabled
> Oct 07 16:33:01.33: [31556]: MODEM input buffering disabled
> Oct 07 16:33:01.34: [31556]: --> [2:]
> Oct 07 16:33:01.34: [31556]: --> [2:OK]
> Oct 07 16:33:01.42: [31556]: RECV FAX (00000549): recvq/fax00146.tif from
0121 585 5971, route to <unspecified>, 0 pages in 0:14
> Oct 07 16:33:01.98: [31556]: RECV FAX: T.30 T2 timeout, expected page not
received
> Oct 07 16:33:01.98: [31556]: <-- [9:AT+FTH=3\r]
> Oct 07 16:33:02.84: [31556]: --> [7:CONNECT]
> Oct 07 16:33:02.84: [31556]: <-- HDLC<3:FF C8 5F>
> Oct 07 16:33:03.17: [31556]: --> [2:OK]
> Oct 07 16:33:03.17: [31556]: MODEM input buffering enabled
> Oct 07 16:33:03.17: [31556]: RECV FAX (00000549): session with 0121 585
5971 terminated abnormally: T.30 T2 timeout, expected page not received
> Oct 07 16:33:03.17: [31556]: RECV FAX: bin/faxrcvd "recvq/fax00146.tif"
"ttyS4" "00000549" "T.30 T2 timeout, expected page not received" "" "O"
>


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxxxxx*