RE: flexfax: Re-submit a job or change properties?

["Bernd Proissl" <news@proissl.de>]

> -----Original Message-----
> From: owner-flexfax@celestial.com [mailto:owner-flexfax@celestial.com]On
> Behalf Of Christoph Scheeder
> Sent: Friday, May 05, 2000 4:22 PM
> To: HylaFax Mailing liste
> Subject: Re: flexfax: Re-submit a job or change properties?
> 
> 
> Ulrich Eckhardt schrieb:
> > 
> > Paul Broadwith wrote:
> > >
> > > Hi,
> > >
> > > I'm running HylaxFAX v4.0pl2 on a Red Hat Linux (kernel 
> 2.12-20) server. I'm
> > > using WHFC 1.07 to connect to it from an NT workstation.
> > >
> > > I sent a fax just today and, after it had dialled, I realised 
> it was the
> > > wrong fax number I had been given. I had to do a reprint of 
> the document, no
> > > big deal, but is there a way to change the properties (read telephone
> > > number) of a fax from the workstation once it has been sent?
> > 
> > Hi,
> > 
> > AFAIK there is currently no way to change the phone number. Also
> > i don't remember that there is an option in the HylaFAX
> > protocol for this.
> 
> Hi,
> I think i must correct you,
> you can querry the number a job is sceduled for with the command 
> "JPARM DIALSTRING" and you can change it with the same command.
> But first off those actions you have to suspend the job( JSUSP job-id),
> and then set the job as the current job (with JOB job-id).
> Now you can querry and set (nearly) all parameters of the job new.
> Trust me, i have tried it.
> Christoph

Christoph, 
is this true if job state is "done"?

Bernd
> -- 
> Christoph Scheeder                  Tel:   07247/946040
> Scheeder & Partner GmbH	            Fax:   07247/946040
> Schillerstrasse 8                   Email:
> christoph.scheeder@scheeder.de
> D-76351 Linkenheim-Hochstetten      www:   www.scheeder.de
>