[hylafax-users] Configuring Eicon DIVA 4BRI with hylafax.

Does any body know how to correctly configure HylaFAX with the Eicon DIVA 4BRI card. I have tried it by setting up the following packages.

1. divas4linux_EICON-105.541-1.i386
2. capi4k-utils-2005-07-18
3. hylafax-4.2.3
4. capi4hylafax-01.03.00
5. Linux kernel 2.6.12

I cant figure out how to tell HylaFAX about my virtual modem device: /dev/capi20.

I have managed to start c2faxrecv which displays the following message:
------------------------------------------------------------------------------------------------------
[root@localhost ~]# The config file is /etc/config.faxCAPI.
C4H-Version 01.03.00 (32Bit).
The SpoolDirectory is /var/spool/hylafax.
Changed to effective user "fax" and group "dialout" succesfully.
Device "faxCAPI" uses 2 receive thread(s) with the following config:
Controller=1 : accept all

Started in Hylafax mode and waiting on inc oming calls.
----------------------------------------------------------------------------------------------------

But it does not respond to an incoming fax.

The /var/log/messages file at the other end says:
---------------------------------------------------------------------------------------------------------------
SEND FAILED: JOB 64 DEST 2792538 ERR Ring detect without successful handshake
----------------------------------------------------------------------------------------------------------------