Re: [hylafax-users] Faxstate

[Joe <joe@xxxxxxxxxxxxxxx>]

Not positive but I think the state you are setting
needs double quotes.

Roper, Brent wrote:
> This is a hylafax 4.2.2 beta1 that was built from source.  It has 6
> lines on it and is being used to receive and send.  Faxgetty is running
> for all 6 lines.  The problem I am having is when I use:
> 
>  
> 
>  faxstate –s down ttyS0
> 
>  faxstate –s down ttyS1
> 
>  faxstate –s down ttyS4
> 
>  
> 
>  or use the busy command it only works for a little while and then it
> starts sending out on all 6 lines again.  The PID stays the same for
> faxgetty process.
> 
>  
> 
>  
> 
>  
> 
> **Brent Roper**
> 
> 9210 Cameron Rd Suite 800
> 
> Austin, TX  78754
> 
> Phone: 512-928-8282
> 
> Fax: 512-928-1825
> 
> //This information transmitted is intended only for the person or entity
> to which it is addressed and may contain confidential and/or privileged
> material, the disclosure of which is governed by applicable law.  Any
> review, retransmission, dissemination or other use of, or taking of any
> action in reliance upon, this information by persons or entities other
> than the intended recipient is prohibited.  If you received this in
> error, please contact the sender and destroy the materials contained in
> this message.//////
> 
>  
> 


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*