|
Report any problems to
webmaster@hylafax.org
HylaFAX is a trademark of Silicon Graphics Corporation. Internet connectivity for hylafax.org is provided by: VirtuALL Private Host Services |
| Hylafax Mailing List Archives |
|
I've set up a faxserver which sends
and receives faxes.
When receiving faxes i sometimes get the
following error:
recvq/fax000000178.tif (ftp://faxsrv:4559/recvq/fax000000178.tif):
Sender: 0332217924 Pages: 1 Quality: Fine Page: 1728 by 196 Received: 2004:12:14 13:40:05 TimeToRecv: 0:15 SignalRate: 14400 bit/s DataFormat: 2-D MMR ErrCorrect: Yes ReceivedOn: ttyS1 The full document was not received
because:
Failed to properly
detect high-speed data carrier.
---- Transcript of
session follows ----
Dec 14 13:39:41.54: [ 8498]: SESSION BEGIN
000000222 310492324326
Dec 14 13:39:41.54: [ 8498]: HylaFAX (tm) Version 4.2.0 Dec 14 13:39:41.54: [ 8498]: <-- [4:ATA\r] Dec 14 13:39:55.12: [ 8498]: --> [7:CONNECT] Dec 14 13:39:55.12: [ 8498]: ANSWER: FAX CONNECTION DEVICE '/dev/ttyS1' Dec 14 13:39:55.12: [ 8498]: RECV FAX: begin Dec 14 13:39:57.00: [ 8498]: --> [7:CONNECT] Dec 14 13:39:57.77: [ 8498]: --> [7:CONNECT] Dec 14 13:39:58.22: [ 8498]: --> [2:OK] Dec 14 13:39:58.22: [ 8498]: <-- [9:AT+FRH=3\r] Dec 14 13:39:58.94: [ 8498]: --> [7:CONNECT] Dec 14 13:40:01.03: [ 8498]: --> [2:OK] Dec 14 13:40:01.03: [ 8498]: REMOTE TSI "0332217924" Dec 14 13:40:01.03: [ 8498]: <-- [9:AT+FRH=3\r] Dec 14 13:40:01.05: [ 8498]: --> [7:CONNECT] Dec 14 13:40:01.07: [ 8498]: --> [2:OK] Dec 14 13:40:01.07: [ 8498]: REMOTE wants 14400 bit/s Dec 14 13:40:01.07: [ 8498]: REMOTE wants A4 page width (215 mm) Dec 14 13:40:01.07: [ 8498]: REMOTE wants unlimited page length Dec 14 13:40:01.07: [ 8498]: REMOTE wants 7.7 line/mm Dec 14 13:40:01.07: [ 8498]: REMOTE wants 2-D MMR Dec 14 13:40:01.07: [ 8498]: REMOTE wants T.30 Annex A, 256-byte ECM Dec 14 13:40:01.07: [ 8498]: RECV training at v.17 14400 bit/s Dec 14 13:40:01.07: [ 8498]: <-- [11:AT+FRM=145\r] Dec 14 13:40:02.70: [ 8498]: --> [7:CONNECT] Dec 14 13:40:04.27: [ 8498]: RECV: TCF 2808 bytes, 6% non-zero, 2614 zero-run Dec 14 13:40:04.27: [ 8498]: --> [10:NO CARRIER] Dec 14 13:40:04.27: [ 8498]: DELAY 75 ms Dec 14 13:40:04.35: [ 8498]: TRAINING succeeded Dec 14 13:40:04.35: [ 8498]: <-- [9:AT+FTH=3\r] Dec 14 13:40:04.41: [ 8498]: --> [7:CONNECT] Dec 14 13:40:05.61: [ 8498]: --> [2:OK] Dec 14 13:40:05.61: [ 8498]: <-- [11:AT+FRM=146\r] Dec 14 13:40:06.64: [ 8498]: --> [7:CONNECT] Dec 14 13:40:10.03: [ 8498]: RECV received frame number 0 Dec 14 13:40:10.25: [ 8498]: RECV received frame number 1 Dec 14 13:40:10.40: [ 8498]: RECV received frame number 2 Dec 14 13:40:10.55: [ 8498]: RECV received frame number 3 Dec 14 13:40:10.70: [ 8498]: RECV received frame number 4 Dec 14 13:40:10.86: [ 8498]: RECV received frame number 5 Dec 14 13:40:10.94: [ 8498]: RECV received frame number 6 Dec 14 13:40:11.09: [ 8498]: RECV received frame number 7 Dec 14 13:40:11.31: [ 8498]: RECV received frame number 8 Dec 14 13:40:11.47: [ 8498]: RECV received frame number 9 Dec 14 13:40:11.61: [ 8498]: RECV received frame number 10 Dec 14 13:40:11.77: [ 8498]: RECV received frame number 11 Dec 14 13:40:11.85: [ 8498]: RECV received frame number 12 Dec 14 13:40:12.01: [ 8498]: RECV received frame number 13 Dec 14 13:40:12.16: [ 8498]: RECV received frame number 14 Dec 14 13:40:12.31: [ 8498]: RECV received frame number 15 Dec 14 13:40:12.46: [ 8498]: RECV received frame number 16 Dec 14 13:40:12.62: [ 8498]: RECV received frame number 17 Dec 14 13:40:12.77: [ 8498]: RECV received frame number 18 Dec 14 13:40:12.93: [ 8498]: RECV received frame number 19 Dec 14 13:40:13.09: [ 8498]: RECV received frame number 20 Dec 14 13:40:13.24: [ 8498]: RECV received frame number 21 Dec 14 13:40:13.40: [ 8498]: RECV received frame number 22 Dec 14 13:40:13.56: [ 8498]: RECV received frame number 23 Dec 14 13:40:13.71: [ 8498]: RECV received frame number 24 Dec 14 13:40:13.87: [ 8498]: RECV received frame number 25 Dec 14 13:40:14.02: [ 8498]: RECV received frame number 26 Dec 14 13:40:14.17: [ 8498]: RECV received frame number 27 Dec 14 13:40:14.33: [ 8498]: RECV received frame number 28 Dec 14 13:40:14.47: [ 8498]: RECV received frame number 29 Dec 14 13:40:14.63: [ 8498]: RECV received frame number 30 Dec 14 13:40:14.78: [ 8498]: RECV received frame number 31 Dec 14 13:40:14.86: [ 8498]: RECV received frame number 32 Dec 14 13:40:15.07: [ 8498]: RECV received frame number 33 Dec 14 13:40:15.22: [ 8498]: RECV received frame number 34 Dec 14 13:40:15.36: [ 8498]: RECV received frame number 35 Dec 14 13:40:15.51: [ 8498]: HDLC frame not byte-oriented. Trailing byte: 0 Dec 14 13:40:15.79: [ 8498]: RECV received frame number 38 Dec 14 13:40:15.93: [ 8498]: RECV received frame number 39 Dec 14 13:40:16.08: [ 8498]: RECV received frame number 40 Dec 14 13:40:16.08: [ 8498]: RECV received RCP frame Dec 14 13:40:16.22: [ 8498]: --> [10:NO CARRIER] Dec 14 13:40:16.22: [ 8498]: <-- [9:AT+FRH=3\r] Dec 14 13:40:16.41: [ 8498]: --> [7:CONNECT] Dec 14 13:40:17.55: [ 8498]: --> [2:OK] Dec 14 13:40:17.55: [ 8498]: RECV recv PPS (partial page signal) Dec 14 13:40:17.55: [ 8498]: RECV recv EOP (no more pages or documents) Dec 14 13:40:17.55: [ 8498]: RECV received 41 frames of block 1 of page 1 Dec 14 13:40:17.55: [ 8498]: DELAY 70 ms Dec 14 13:40:17.62: [ 8498]: <-- [9:AT+FTH=3\r] Dec 14 13:40:17.64: [ 8498]: --> [7:CONNECT] Dec 14 13:40:19.82: [ 8498]: --> [2:OK] Dec 14 13:40:19.82: [ 8498]: RECV send PPR (partial page request) Dec 14 13:40:19.82: [ 8498]: <-- [11:AT+FRM=146\r] Dec 14 13:40:19.94: [ 8498]: --> [5:ERROR] Dec 14 13:40:19.94: [ 8498]: RECV keeping unconfirmed page Dec 14 13:40:19.96: [ 8498]: RECV: 10496 bytes of data, 1513 total lines Dec 14 13:40:19.96: [ 8498]: RECV FAX (000000222): from 0332217924, page 1 in 0:15, INF, 7.7 line/mm, 2-D MMR, 14400 bit/s Dec 14 13:40:19.96: [ 8498]: RECV FAX (000000222): recvq/fax000000178.tif from 0332217924, route to <unspecified>, 1 pages in 0:24 Dec 14 13:40:19.96: [ 8498]: RECV FAX: Failed to properly detect high-speed data carrier. Dec 14 13:40:19.96: [ 8498]: <-- [9:AT+FTH=3\r] Dec 14 13:40:19.99: [ 8498]: --> [7:CONNECT] Dec 14 13:40:21.10: [ 8498]: --> [2:OK] Dec 14 13:40:21.10: [ 8498]: RECV FAX (000000222): session with 0332217924 terminated abnormally: Failed to properly detect high-speed data carrier. Dec 14 13:40:21.10: [ 8498]: RECV FAX: bin/faxrcvd "recvq/fax000000178.tif" "ttyS1" "000000222" "Failed to properly detect high-speed data carrier." "" "" Dec 14 13:40:21.10: [ 8498]: RECV FAX: end Dec 14 13:40:21.10: [ 8498]: SESSION END /var/spool/hylafax/etc/config.ttyS1
:
ServerTracing: 1 SessionTracing: 11 RecvFileMode: 0666 LogFileMode: 0600 DeviceMode: 0600 RingsBeforeAnswer: 1 SpeakerVolume: off GettyArgs: "-h %l dx_%s" LocalIdentifier: "Van Boxtel Software BV" TagLineFont: etc/lutRS18.pcf TagLineFormat: "From %%l|%c|Page %%P of %%T" MaxRecvPages: 25 ModemType: Class1 # hint to override class 2 ModemRate: 19200 # locked for fax sending ModemFlowControl: xonxoff # default ModemSetupDTRCmd: AT&D2 # DTR off causes modem to hangup ModemSetupDCDCmd: AT&C0 # DCD always on ModemMfrQueryCmd: !Nuvo ModemModelQueryCmd: !9624PFX ModemRevQueryCmd: ATI3 ModemDialCmd: ATDT%s # T for tone dialing |
|
|
|