Re: [hylafax-users] High Error Rates still

[Lee Howard <faxguy@xxxxxxxxxxxxxxxx>]

On 2004.07.30 12:44 Stephen Carville wrote:

> Currently I am using:
>
> ttyS0: 56K External Modem Venus V.92 (69% of trafffic)
> ttyS4: USRobotics Courier V.Everything (28% of traffic)
> ttyS5: USRobotics Courier V.Everything (3% of traffic)
>
> (These are modems that were lying around the shop and some are pretty
> old)
>
> All are configured as class 1
>
> > What version of HylaFAX are you using?
>
> 4.1.8
>
> > What are the typical receiving errors that you see?
>
> Among the more popular ones:
>
> Unspecified Phase C error, including too much delay between TCF and
> +FDR
> command

This error message can only occur in Class 2/2.0/2.1.  So, on which 
modems are you running Class 2/2.0/2.1?

> T.30 T2 timeout, expected page not received
>
> Teh most popular error is sometinhg like:
>
> RECV: 123 total lines, 85 bad lines, 13 consecutive bad lines
> RECV: REJECT page quality, 30% good lines (95% required)
>
> This particular fax was resent about 2 minutes later with similar
> results:
>
> RECV: 123 total lines, 84 bad lines, 12 consecutive bad lines
> RECV: REJECT page quality, 31% good lines (95% required)

Well, off-hand I can't say anything other than what that error message 
says.  If you showed the whole log then maybe I could help more, but I 
think that the conclusion would be the same:

Upgrade to 4.2.0 and see how you fare.  Make sure that you run Class 1 
or Class 1.0.

Lee.

____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*