Re: [hylafax-users] Two more, please. was: Re: Three Configuration Questions . . .

[Matt <mathfretwell@xxxxxxxxxxxxxxxx>]

> Two more questions:  
> 
> Question #5)  
> What is the proper syntax for the -h parameter for sendfax: 
> 	-h "ttyS1@localhost"?  
> 
> After some experimentation, it seems to accept this syntax.  
>

 That's seems fine, though you dont need the quotes. Shouldn't matter though.

> 
> Question #4)  
> Where would I start looking to determine why a line that has an
> etc/config.ttyS1 file and is properly cabled to a phone line has not
> shared the work load in getting this fax out?  
> 

 Your log below is the answer to that question. This modem has a problem.
I, however, have no idea what could be causing this. This is a problem better
answered by Lee.

> 
> But I'm still getting errors as outlined below.  
> May 28 18:09:04.43: [22368]: SESSION BEGIN 00000223 14048060584
> May 28 18:09:04.43: [22368]: HylaFAX (tm) Version 4.1.8
> May 28 18:09:04.43: [22368]: SEND FAX: JOB 220 DEST 1-404-806-0584
> COMMID 00000223 DEVICE '/dev/ttyS1'
> May 28 18:09:14.02: [22368]: STATE CHANGE: RUNNING -> SENDING
> May 28 18:13:05.24: [22368]: SEND: DCS sent 3 times without response;
> Giving up after 3 attempts to send same page "docq/doc10.ps;30", dirnum
> 0
> May 28 18:13:05.50: [22368]: STATE CHANGE: SENDING -> MODEMWAIT (timeout
> 5)
> May 28 18:13:05.50: [22368]: SESSION END
> 

Matt


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*