Re: [hylafax-users] CID / DID problem - update to solution

[Lee Howard <faxguy@xxxxxxxxxxxxxxxx>]

On 2003.12.13 10:37 Impact wrote:

> Can you point me to a how-to to apply a "CVS HEAD"?

See http://www.hylafax.org/cvs.html

> Tricks on getting 2D-MMR going?  Using modems in class 2.0

It should work out-of-the-box.  In theory, you should be able to 
install HylaFAX, run faxsetup/faxaddmodem, send a fax to a mmr-capable 
receiver (it will go through with 1D-MH the first time), send a fax to 
the same receiver again, and it should have gone through in 2D-MMR.

As for receiving, you should be able to receive MMR faxes from an 
MMR-sender immediately.  But, you've disabled this in your modem config 
file.

The difference in HylaFAX CVS HEAD (to be 4.2.0) from all of that is 
that if you enable ModemSoftRTFCC the fax sent to an MMR receiver will 
go through with MMR on the first attempt rather than on the second.  
Since your modem supports Class2RTFCC, this probably is of little value 
to you.  So, as long as you run the modem in Class 2.0 (and I don't 
recommend Class 1 on Digi, as far as I've seen), CVS HEAD won't be of 
much benefit to you as far as session capabilities go.

Lee.

____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxxxxx*