[hylafax-users] Irregular image of received fax!?

["Titan Tanto" <titantanto@hotmail.com>]

I am using Red Hat Linux 9.0 and Hylafax 4.1.6 (as rpm).
I often receive fax as shown in the attachment which different from the
senders'.
What's going wrong?
 This is the log:
Thanks!

> The full document was not received because:
>
>     Unspecified Phase C error, including too much delay between TCF and
+FDR command
>
>     ---- Transcript of session follows ----
>
> Aug 30 15:04:48.95: [ 6422]: SESSION BEGIN
> Aug 30 15:04:48.95: [ 6422]: HylaFAX (tm) Version 4.1.6
> Aug 30 15:04:48.95: [ 6422]: <-- [4:ATA\r]
> Aug 30 15:04:51.89: [ 6422]: --> [3:FAX]
> Aug 30 15:04:57.98: [ 6422]: --> [5:+FCON]
> Aug 30 15:04:57.98: [ 6422]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyS0'
> Aug 30 15:04:57.98: [ 6422]: RECV FAX: begin
> Aug 30 15:04:59.58: [ 6422]: --> [29:+FTSI: "     + 852 2488 9944"]
> Aug 30 15:04:59.58: [ 6422]: REMOTE TSI "+ 852 2488 9944"
> Aug 30 15:04:59.99: [ 6422]: --> [22:+FDCS: 1,5,0,2,0,0,0,0]
> Aug 30 15:04:59.99: [ 6422]: REMOTE wants 14400 bit/s
> Aug 30 15:04:59.99: [ 6422]: REMOTE wants page width 1728 pixels in 215 mm
> Aug 30 15:04:59.99: [ 6422]: REMOTE wants unlimited page length
> Aug 30 15:04:59.99: [ 6422]: REMOTE wants 7.7 line/mm
> Aug 30 15:04:59.99: [ 6422]: REMOTE wants 1-D MR
> Aug 30 15:04:59.99: [ 6422]: --> [2:OK]
> Aug 30 15:04:59.99: [ 6422]: <-- [7:AT+FDR\r]
> Aug 30 15:05:02.94: [ 6422]: --> [5:+FCFR]
> Aug 30 15:05:05.40: [ 6422]: --> [22:+FDCS: 1,5,0,2,0,0,0,0]
> Aug 30 15:05:05.40: [ 6422]: REMOTE wants 14400 bit/s
> Aug 30 15:05:05.40: [ 6422]: REMOTE wants page width 1728 pixels in 215 mm
> Aug 30 15:05:05.40: [ 6422]: REMOTE wants unlimited page length
> Aug 30 15:05:05.40: [ 6422]: REMOTE wants 7.7 line/mm
> Aug 30 15:05:05.40: [ 6422]: REMOTE wants 1-D MR
> Aug 30 15:05:05.40: [ 6422]: --> [7:CONNECT]
> Aug 30 15:05:05.40: [ 6422]: RECV: begin page
> Aug 30 15:05:05.40: [ 6422]: RECV: send trigger 022
> Aug 30 15:05:15.41: [ 6422]: RECV: 360 total lines, 0 bad lines, 0
consecutive bad lines
> Aug 30 15:05:15.41: [ 6422]: --> [17:+FPTS: 1,2219,0,0]
> Aug 30 15:05:22.44: [ 6422]: --> [7:+FET: 0]
> Aug 30 15:05:22.44: [ 6422]: RECV recv MPS (more pages, same document)
> Aug 30 15:05:22.55: [ 6422]: --> [2:OK]
> Aug 30 15:05:22.55: [ 6422]: RECV send MCF (message confirmation)
> Aug 30 15:05:22.55: [ 6422]: RECV FAX (00000769): from + 852 2488 9944,
page 1 in 0:23, INF, 7.7 line/mm, 1-D MR, 14400 bit/s
> Aug 30 15:05:22.55: [ 6422]: <-- [7:AT+FDR\r]
> Aug 30 15:05:24.90: [ 6422]: --> [7:CONNECT]
> Aug 30 15:05:24.90: [ 6422]: RECV: begin page
> Aug 30 15:05:24.90: [ 6422]: RECV: send trigger 022
> Aug 30 15:05:25.68: [ 6422]: RECV: 23 total lines, 0 bad lines, 0
consecutive bad lines
> Aug 30 15:05:25.68: [ 6422]: --> [17:+FPTS: 1,2219,0,0]
> Aug 30 15:05:55.68: [ 6422]: MODEM <Timeout>
> Aug 30 15:05:55.68: [ 6422]: REMOTE HANGUP: Unspecified Phase C error,
including too much delay between TCF and +FDR command (code 90)
> Aug 30 15:05:55.68: [ 6422]: RECV FAX (00000769): recvq/fax00721.tif from
+ 852 2488 9944, route to <unspecified>, 1 pages in 0:58
> Aug 30 15:05:55.68: [ 6422]: RECV FAX: Unspecified Phase C error,
including too much delay between TCF and +FDR command
> Aug 30 15:05:55.68: [ 6422]: <-- [6:AT+FK\r]
> Aug 30 15:06:25.68: [ 6422]: MODEM <Timeout>
> Aug 30 15:06:25.68: [ 6422]: RECV FAX (00000769): session with + 852 2488
9944 terminated abnormally: Unspecified Phase C error, including too much
delay between TCF and +FDR command
> Aug 30 15:06:25.68: [ 6422]: RECV FAX: bin/faxrcvd "recvq/fax00721.tif"
"ttyS0" "00000769" "Unspecified Phase C error, including too much delay
between TCF and +FDR command" "" ""
>

fax00721.tif