Re: [hylafax-users] New Firmware for Multitech ZPX Available

[Frank Peters <frank.peters@comcast.net>]

On Wed, 21 May 2003 12:27:25 -0700
Lee Howard <faxguy@howardsilvan.com> wrote:

> 
> Does this not happen when RTFCC is disabled?
> 

With the new firmware, I tried to send a fax in Class 2.0 to
the same machine as in the previous post.  It worked without error.

Then I tried Class 2.0 + RFTCC enabled, again to the same machine.
It failed, but not in the same way as with Class 2.1.  Actually it
was a two-page fax and the first page got through but then:

May 21 18:03:53.45: [  302]: SEND send MPS (more pages, same document)
May 21 18:03:53.45: [  302]: <-- data [2]
May 21 18:04:11.04: [  302]: --> [7:+FHS:52]
May 21 18:04:11.04: [  302]: REMOTE HANGUP: No response to MPS repeated 3 times (code 52)
May 21 18:04:11.04: [  302]: <-- [5:ATH0\r]
May 21 18:04:11.29: [  302]: --> [2:OK]
May 21 18:04:11.29: [  302]: SESSION END

So, after re-flashing the firmware 1.32c several times, I get the following:

Class 2.1 + RTFCC enabled -- failed transmision, modem hangs
Class 2.1 + RTFCC disabled -- failed transmission, modem hangs 

Class 2.0 + RTFCC enabled -- first page OK, but see above log
Class 2.0 + RTFCC disabled -- no problems

If anyone else has tried the 1.32c firmware for this modem, please report
your results.

With the previous firmware version, 1.25p, Class 2.1 and V.34 functioned
without problem.

Frank Peters

____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*