Re: [hylafax-users] how to set calling party number ?

["Joey Officer" <jofficer@houston.rr.com>]

Although I'm not sure if this applies to specifically what you are working
with, look in /var/spool/hylafax/etc/confix.ttyS2 (where ttyS2 is my modem,
yours will vary)  That is where the information is stored, I don't know if
you could append that on the fly to contain the information you require.

Hope that points you in the right direction...

Joey


-----Original Message-----
From: hylafax-users-bounce@hylafax.org
[mailto:hylafax-users-bounce@hylafax.org]On Behalf Of Markus Storm
Sent: Monday, November 04, 2002 4:43 AM
To: hylafax-users@hylafax.org
Subject: [hylafax-users] how to set calling party number ?


Hi all,

I am using Hylafax with a virtual modem (t38modem from OpenH323, to
enable Fax over IP). Works great, in and out.

I'm using it as a mail2fax gateway and would like to set the CLID
(calling line identity a.k.a. sender's number) on outbound calls .
faxmail and sendfax -f use the sender's address to put it
onto the cover sheet only, but they don't set the CLID.

Is there any (Class 1 fax modem) command to do that ?
Any support for this from within Hylafax ?

Thanks,
Markus

--
  Markus Storm, mediaWays GmbH, Verl, Germany
  storm @ mediaways.net

____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*