[hylafax-users] Missing EOL after 5 seconds error

["Keith Waters" <kwlist@waters.co.za>]

Hi  - I am getting the following error (see full error below) on  SOME
incoming faxes on my Eicon Diva 2fx.  I added the modems using the configs
Eicon sent me

I got the following info off the Internet:

"   RECV: Missing EOL after 5 seconds.   The  server  timed  out
     while  receiving  page  data.  This typically is caused by a
     flow control configuration problem that causes data from the
     modem to the host to be stopped."  - man page

" The modem failed to receive any fax image data after being sent control-Q.
"  - from hylafax message archive

This seems to always happen when receiving faxes from the program
'Rightfax' - could be something, or could be a coincidence.

Have you any ideas how I would solve this one, please?

Thanks
regards,
Keith

Subject: facsimile not received
Date: Wed, 31 Jul 2002 10:57:36 +0200
From: The Intercape Fax Receiver <fax@fax.intercape.co.za>
To: FaxMaster@fax.intercape.co.za



An attempt to receive facsimile on ttyds01 failed because:

    Missing EOL after 5 seconds (section 3.2/T.4)

    ---- Transcript of session follows ----

Jul 31 10:54:51.03: [  252]: SESSION BEGIN 00000984 27213802088
Jul 31 10:54:51.03: [  252]: HylaFAX (tm) Version 4.1.1
Jul 31 10:54:51.03: [  252]: <-- [4:ATA\r]
Jul 31 10:55:05.77: [  252]: --> [5:+FCON]
Jul 31 10:55:05.77: [  252]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyds01'
Jul 31 10:55:05.77: [  252]: MODEM input buffering enabled
Jul 31 10:55:05.77: [  252]: RECV FAX: begin
Jul 31 10:55:05.77: [  252]: --> [26:+FTSI:       STANDARD BANK]
Jul 31 10:55:05.77: [  252]: REMOTE TSI "STANDARD BANK"
Jul 31 10:55:05.77: [  252]: --> [22:+FDCS: 1,5,0,2,0,2,0,0]
Jul 31 10:55:05.77: [  252]: REMOTE wants 14400 bit/s
Jul 31 10:55:05.77: [  252]: REMOTE wants page width 1728 pixels in 215 mm
Jul 31 10:55:05.77: [  252]: REMOTE wants unlimited page length
Jul 31 10:55:05.77: [  252]: REMOTE wants 7.7 line/mm
Jul 31 10:55:05.77: [  252]: REMOTE wants 1-D MR
Jul 31 10:55:05.77: [  252]: REMOTE wants T.30 Annex C, half duplex ECM
Jul 31 10:55:05.77: [  252]: --> [2:OK]
Jul 31 10:55:05.77: [  252]: <-- [7:AT+FDR\r]
Jul 31 10:55:05.87: [  252]: --> [5:+FCFR]
Jul 31 10:55:05.87: [  252]: --> [22:+FDCS: 1,5,0,2,0,2,0,0]
Jul 31 10:55:05.87: [  252]: REMOTE wants 14400 bit/s
Jul 31 10:55:05.87: [  252]: REMOTE wants page width 1728 pixels in 215 mm
Jul 31 10:55:05.87: [  252]: REMOTE wants unlimited page length
Jul 31 10:55:05.87: [  252]: REMOTE wants 7.7 line/mm
Jul 31 10:55:05.87: [  252]: REMOTE wants 1-D MR
Jul 31 10:55:05.87: [  252]: REMOTE wants T.30 Annex C, half duplex ECM
Jul 31 10:55:05.87: [  252]: --> [7:CONNECT]
Jul 31 10:55:05.87: [  252]: RECV: begin page
Jul 31 10:55:05.87: [  252]: RECV: send trigger 021
Jul 31 10:55:16.64: [  252]: RECV: 2199 total lines, 0 bad lines, 0
consecutive bad lines
Jul 31 10:55:16.64: [  252]: --> [13:+FPTS: 1,2200]
Jul 31 10:55:16.64: [  252]: --> [7:+FET: 1]
Jul 31 10:55:16.64: [  252]: RECV recv EOM (more documents)
Jul 31 10:55:16.64: [  252]: --> [2:OK]
Jul 31 10:55:16.64: [  252]: RECV send MCF (message confirmation)
Jul 31 10:55:16.64: [  252]: RECV FAX (00000984): from STANDARD BANK, page 1
in 0:11, INF, 7.7 line/mm, 1-D MR, 14400 bit/s
Jul 31 10:55:16.64: [  252]: RECV FAX (00000984): recvq/fax00215.tif from
STANDARD BANK, route to <unspecified>, 1 pages in 0:11
Jul 31 10:55:16.64: [  252]: <-- [7:AT+FDR\r]
Jul 31 10:55:32.53: [  252]: --> [22:+FDCS: 0,5,0,2,0,2,0,0]
Jul 31 10:55:32.53: [  252]: REMOTE wants 14400 bit/s
Jul 31 10:55:32.53: [  252]: REMOTE wants page width 1728 pixels in 215 mm
Jul 31 10:55:32.53: [  252]: REMOTE wants unlimited page length
Jul 31 10:55:32.53: [  252]: REMOTE wants 3.85 line/mm
Jul 31 10:55:32.53: [  252]: REMOTE wants 1-D MR
Jul 31 10:55:32.53: [  252]: REMOTE wants T.30 Annex C, half duplex ECM
Jul 31 10:55:32.53: [  252]: --> [2:OK]
Jul 31 10:55:32.53: [  252]: RECV: begin page
Jul 31 10:55:32.53: [  252]: RECV: send trigger 021
Jul 31 10:57:35.57: [  252]: MODEM TIMEOUT: reading from modem
Jul 31 10:57:35.57: [  252]: RECV: Missing EOL after 5 seconds
Jul 31 10:57:35.57: [  252]: REMOTE HANGUP: Missing EOL after 5 seconds
(section 3.2/T.4) (code 91)
Jul 31 10:57:35.57: [  252]: RECV FAX (00000984): recvq/fax00216.tif from
STANDARD BANK, route to <unspecified>, 0 pages in 2:19
Jul 31 10:57:35.57: [  252]: RECV FAX: Missing EOL after 5 seconds (section
3.2/T.4)
Jul 31 10:57:35.57: [  252]: <-- [6:AT+FK\r]
Jul 31 10:57:35.67: [  252]: --> [5:ERROR]
Jul 31 10:57:35.67: [  252]: MODEM Command error
Jul 31 10:57:35.67: [  252]: RECV FAX: bin/faxrcvd "recvq/fax00215.tif"
"ttyds01" "00000984" "" "" "RING CID:  DAD: 2080"
Jul 31 10:57:35.90: [  252]: RECV FAX (00000984): session with STANDARD BANK
terminated abnormally: Missing EOL after 5 seconds (section 3.2/T.4)
Jul 31 10:57:35.90: [  252]: RECV FAX: bin/faxrcvd "recvq/fax00216.tif"
"ttyds01" "00000984" "Missing EOL after 5 seconds (section 3.2/T.4)" ""
"RING CID:  DAD: 2080"





____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*