[hylafax-users] Hylafax server error, Can't not run

Jul 31 11:36:57 faxserv hylafax: hfaxd startup succeeded
Jul 31 11:36:57 faxserv FaxGetty[1773]: CAUGHT SIGNAL 15
Jul 31 11:36:57 faxserv FaxGetty[1773]: CLOSE /dev/ttyS0
Jul 31 11:36:57 faxserv FaxGetty[1826]: OPEN /dev/ttyS0 HylaFAX (tm) Version 4.1.3
Jul 31 11:36:57 faxserv FaxGetty[1826]: MODEM set DTR OFF
Jul 31 11:36:57 faxserv FaxGetty[1826]: DELAY 75 ms
Jul 31 11:36:57 faxserv FaxGetty[1826]: MODEM set DTR ON
Jul 31 11:36:57 faxserv FaxGetty[1826]: DELAY 2600 ms
Jul 31 11:36:57 faxserv hylafax: faxgetty shutdown succeeded
Jul 31 11:37:00 faxserv FaxGetty[1826]: MODEM set baud rate: 19200 baud, input flow RTS/CTS, output flow RTS/CTS
Jul 31 11:37:00 faxserv FaxGetty[1826]: MODEM flush i/o
Jul 31 11:37:00 faxserv FaxGetty[1826]: <-- [4:ATZ\r]
Jul 31 11:37:30 faxserv FaxGetty[1826]: MODEM TIMEOUT: reading line from modem
Jul 31 11:37:30 faxserv FaxGetty[1826]: MODEM <Timeout>
Jul 31 11:37:30 faxserv FaxGetty[1826]: MODEM set DTR OFF
Jul 31 11:37:30 faxserv FaxGetty[1826]: DELAY 75 ms
Jul 31 11:37:30 faxserv FaxGetty[1826]: MODEM set DTR ON
Jul 31 11:37:30 faxserv FaxGetty[1826]: DELAY 2600 ms
Jul 31 11:37:32 faxserv FaxGetty[1826]: MODEM set baud rate: 19200 baud, input flow RTS/CTS, output flow RTS/CTS
Jul 31 11:37:32 faxserv FaxGetty[1826]: MODEM flush i/o
Jul 31 11:37:32 faxserv FaxGetty[1826]: <-- [4:ATZ\r]
Jul 31 11:38:02 faxserv FaxGetty[1826]: MODEM TIMEOUT: reading line from modem
Jul 31 11:38:02 faxserv FaxGetty[1826]: MODEM <Timeout>
Jul 31 11:38:02 faxserv FaxGetty[1826]: MODEM set DTR OFF
Jul 31 11:38:02 faxserv FaxGetty[1826]: /dev/ttyS0: Can not initialize modem.
Jul 31 11:38:02 faxserv FaxGetty[1826]: STATE CHANGE: BASE -> MODEMWAIT (timeout 30)

CountryCode:            66
AreaCode:               2
FAXNumber:              +12.3.456.7890
LongDistancePrefix:     0
InternationalPrefix:    001
DialStringRules:        etc/dialrules
ServerTracing:          0xFFF
SessionTracing:         11
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      3
SpeakerVolume:          high
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        "NothingSetup"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%P of %%T"
NoCarrierRetrys:        3
MaxRecvPages:           25
#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:              class1          # use class 1 interface
ModemRate:              19200
ModemFlowControl:       rtscts          # default
#
ModemHardFlowCmd:       AT&R0\D1\Q3     # use RTS/CTS and enable RS232 handling
ModemSoftFlowCmd:       AT&R1\D0\Q1     # use RTS/CTS and enable RS232 handling
ModemSetupDTRCmd:       AT&D2           # setup so DTR drop resets modem
ModemSetupDCDCmd:       AT&C1           # setup so DCD follows carrier
ModemSetupAACmd:        AT+FAA=0        # disable in case of Class 2 support
#
ModemMfrQueryCmd:       !AT&T
ModemModelQueryCmd:     !DataPort
ModemRevQueryCmd:       ATI19