[hylafax-users] Line busy while it's not

["Wouter Vijvers" <woutje@chello.nl>]

Version: Hylafax4.1beta3
OS: NetBSD 1.5 (i386)
Modem: Zoom 14.4 Ex (AFES - V1510b - Rockwell RPI (TM) MODEM Z20)

Hi,
When trying to receive a fax (sent using Cheyenne Bitware on Win95, but
that's not the problem) I get a "0x8111: Phone is busy" error in Bitware and
the following one in log/c00000000x:
Jun 24 20:43:45.77: [  218]: SESSION BEGIN 00000011 312077xxxxx
Jun 24 20:43:45.78: [  218]: <-- [4:ATA\r]
Jun 24 20:46:45.79: [  218]: ANSWER: Ring detected without successful
handshake
Jun 24 20:46:45.79: [  218]: SESSION END

I am pretty sure that the line is NOT busy (modem is not at my house, but
the line is seldom used and it happens 100% of the time). Config file is
attached. What could be going wrong? Oh, faxstat says "Running and idle".

Regards,
Wouter

"I'm too lazy to make a signature..."

=================================
# Configuration for a Rockwell-based Class 1 modem.
#    SupraFAX v.32bis           firmware V1.200-C or newer
# (and others)
#
# This configuration file sets up the modem to run at 38.4
# and use RTS/CTS flow control by default.
#
#
CountryCode:            31
AreaCode:               20
FAXNumber:              "+31 20 77xxxxx"
LongDistancePrefix:     0
InternationalPrefix:    00
DialStringRules:        etc/dialrules.europe
ServerTracing:          1
SessionTracing:         11
RecvFileMode:           0644
LogFileMode:            0600
DeviceMode:             0660
RingsBeforeAnswer:      1
SpeakerVolume:          off
GettyArgs:              "std.%s"
LocalIdentifier:        "NothingSetup"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%P of %%T"
MaxRecvPages:           25
#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:              Class1          # use class 1 interface
ModemRate:              38400
ModemFlowControl:       rtscts          # default
#
ModemNoFlowCmd:         AT:             AT&K0           # disable flow
control cmd
ModemHardFlowCmd:       AT&K3           # hardware flow control cmd
ModemSoftFlowCmd:       AT&K4           # software flow control cmd
ModemSetupDTRCmd:       AT&D3           # setup so DTR drop resets modem

ModemSetupDCDCmd:       AT&C1           # setup so DCD reflects carrier
(or not)
ModemSetupAACmd:        AT+FAA=0        # in case modem supports Class 2
also
#
ModemMfrQueryCmd:       !Rockwell       # no way to query modem
ModemModelQueryCmd:     !RC32ACL        # not always right
ModemRevQueryCmd:       ATI3





____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null