|
Hylafax Mailing List Archives
|
[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index]
[Thread Index]
[hylafax-users] ZyXEL Omni288S Class1
Haho,
I try to configure the subj. modem to class1,
but the default generated config does not work.
The modem state stops at waiting to modem become free.
I'm useing an older config file, which was generated with a rockwell modem.
It seems good.
The default for ZyXEL:
ModemType: Class1 # use class 1 interface
ModemRate: 38400 # locked for fax sending&receiving
#ModemFlowControl: rtscts # default
ModemFlowControl: xonxoff # default
#
ModemNoFlowCmd: AT\Q0 # disable flow control cmd
ModemSoftFlowCmd: AT\Q1 # software flow control cmd
ModemHardFlowCmd: AT\Q3 # hardware flow control cmd
ModemSetupDTRCmd: AT&D3 # DTR off causes modem to reset
ModemSetupDCDCmd: AT&C1 # DCD follows carrier
#
ModemMfrQueryCmd: AT+FMFR? # Class 2 commands work in Class 0
ModemModelQueryCmd: AT+FMDL? # actually shows 144DPI
ModemRevQueryCmd: AT+FREV? # firmware revision info
#
ModemDialCmd: ATDT%s # T for tone dialing
The working one:
Class1Cmd: AT+FCLASS=1 # command to enter class 1
Class1TCFResponseDelay: 75 # 75ms delay between recv TCF &
response
Class1SendPPMDelay: 75 # 75ms delay before sending PPM
Class1SendTCFDelay: 75 # 75ms delay between sending DCS &
TCF
Class1TrainingRecovery: 1500 # 1.5sec delay after training
failure
Class1RecvAbortOK: 200 # wait 200ms for abort response
Class1FrameOverhead: 4 # 4 byte overhead in recvd HDLC
frames
Class1RecvIdentTimer: 40000 # 35+5secs waiting for ident frames
Class1TCFMaxNonZero: 10 # max 10% of data may be non-zero
Class1TCFMinRun: 1000 # min run is 2/3rds of TCF duration
AdaptiveAnswer: yes
Imre.
____________________ HylaFAX(tm) Users Mailing List _______________________
To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
