[hylafax-users] HYLAFAX sending to wrong number

I am running Redhat 6.0 with hylafax and 2 multitech modems. Just 2 days ago I ran into a problem where the faxes were going to a wrong number and I do not know why. Below you can see the portion of the log file where you can see the error. What appears to be happening but I cannot yet verify this is that the fax is going out to the remote id that was last received. You can see that the number dialed was 920 457-1742 but the number that was receiving the fax was 219 398-1194.

Jul 28 13:50:08.75: [ 4117]: <-- [24:AT+FDCC=1,5,2,2,0,0,0,0\r]
Jul 28 13:50:08.86: [ 4117]: --> [2:OK]
Jul 28 13:50:08.86: [ 4117]: <-- [23:AT+FLID="715-848-2930"\r]
Jul 28 13:50:08.97: [ 4117]: --> [2:OK]
Jul 28 13:50:08.97: [ 4117]: DIAL 19204571742
Jul 28 13:50:08.97: [ 4117]: <-- [17:ATDT19204571742@\r]
Jul 28 13:51:00.83: [ 4117]: --> [5:+FCON]
Jul 28 13:51:03.83: [ 4117]: --> [29:+FCSI: " 219 398 1194"]
Jul 28 13:51:03.83: [ 4117]: REMOTE CSI "219 398 1194"
Jul 28 13:51:04.12: [ 4117]: --> [22:+FDIS: 1,5,1,2,1,0,0,4]
Jul 28 13:51:04.23: [ 4117]: --> [2:OK]
Jul 28 13:51:04.23: [ 4117]: REMOTE best rate 14400 bit/s
Jul 28 13:51:04.23: [ 4117]: REMOTE max page width 2048 pixels in 255 mm
Jul 28 13:51:04.23: [ 4117]: REMOTE max unlimited page length
Jul 28 13:51:04.23: [ 4117]: REMOTE best vres 7.7 line/mm
Jul 28 13:51:04.23: [ 4117]: REMOTE best format 2-D MR
Jul 28 13:51:04.23: [ 4117]: REMOTE best 20 ms, 10 ms/scanline
Jul 28 13:51:04.23: [ 4117]: USE 14400 bit/s
Jul 28 13:51:04.23: [ 4117]: USE 20 ms, 10 ms/scanline
Jul 28 13:51:04.23: [ 4117]: SEND file "docq/doc5029.ps;31"