flexfax: MultiTech MT3334ZDX Modem Config Groovin

[Kirk Bocek <kbocek@evhill.com>]

I've almost got my MultiTech MT3334ZDX working thanks to the Rockwell-K56
config fix and some help from Tim Rice here.

However received faxes still have many errors. Some page come through as
just a bunch of noise. I'm pretty sure the problem is in the config file
since I have a second modem on the same machine that seems to be working
fine.

Here's the hardware part of the config file. Anyone seen any glaring errors?

Thanks.

#################################
#
ModemType:		Class2		# use class 2 interface
ModemRate:		38400
ModemFlowControl:	rtscts
ModemWaitForConnect:	yes		# wait for CONNECT on answer
#
ModemNoFlowCmd:	AT&K0		# disable flow control cmd
ModemHardFlowCmd:	AT&K3		# hardware flow control
ModemSoftFlowCmd:	AT&K4		# software flow control
ModemSetupDTRCmd:	AT&D3		# setup so DTR drop resets modem
ModemSetupDCDCmd:	AT&C1		# setup so DCD reflects carrier (or not)
ModemSetupAACmd:	AT+FAA=1	# enable adaptive-answer in class 2
#
# NB: some models get confused by the @
#
ModemDialCmd:		ATDT%s@		# T for tone dialing, @ for silence
#
Class2RecvDataTrigger:	"\022"		# character sent to modem to start recv
#

#
ModemSendFillOrder:	LSB2MSB		# as expected
ModemRecvFillOrder:	MSB2LSB		# opposite of what makes sense
Class2RecvDataTrigger:	"\022"		# a la 2388-B
#
Class2NRCmd:    AT+FNR=1,1,1,0  # setup status reporting command
#
Class2XmitWaitForXON:   no
#
Class2APQueryCmd:       ""              # AT+FAP=? not supported on this
modem
Class2NFLOCmd:          AT+FLO=0        # Class 2: no flow control
Class2SFLOCmd:          AT+FLO=1        # Class 2: software flow control
Class2HFLOCmd:          AT+FLO=2        # Class 2: hardware flow control