flexfax: +FHNG:2 at end of transmission

["R.E. Brouwer" <brouwer@ap-communicaties.nl>]

I'm trying to setup a Multitech MT5634ZPX internal modem with HylaFAX 4.0pl2.

 

When I send a fax, everything goed well, until my modem send the ATH0 command. The Hylafax server then receives a +FHNG:2 from the receiving party and aborts. It does NOT requeue the job, but treeds it like it has been send correctly. My receiving faxmachine reports however that there was a communication error?

 

What's going wrong. Is the config.ttyS1 not setup correctly or is it my modem?

Look at the attachements for details about the session.

 

Please mail me at brouwer@ap-communicaties.nl

 

This is my setup:

 

HylaFAX 4.0pl2

Linux 2.0.34

Multitech MT5634ZPX (internal) on ttyS1 (also tried ttyS2, same problem)

See attachements for my config.ttyS1, messages and logfile

 

 

Remco Brouwer

brouwer@ap-communicaties.nl

 

c00000185

config.ttyS1

messages