Re: flexfax: modem config file for MultiTech mt5634zbav?

["Mark A. Schwenk" <mas@wellthot.com>]

I'm not sure if this is perfect, but what I put together here seems to work
OK for me (I think the important change from the defaults was for the fill
orders):

### Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).#
ModemType:  Class2  # use class 2 interface
ModemRate:  19200  # lock rate for DCE-DTE communication
#ModemFlowControl: rtscts  # defaultModemFlowControl: xonxoff #
ModemHardFlowCmd: AT&E4  # hardware flow control
ModemSoftFlowCmd: AT&E5  # software flow control
ModemSetupDTRCmd: AT&D3  # setup so DTR drop resets modem
ModemSetupDCDCmd: AT&C1  # setup so DCD reflects carrier (or not)
ModemSetupAACmd: AT+FAA=1 # enable adaptive-answer in class 2#
# NB: some models get confused by the @#
#ModemDialCmd:  ATDT%s@  # T for tone dialing, @ for silence
ModemDialCmd:  ATDT%s  # T for tone dialing, @ for silence#
Class2RecvDataTrigger: "\022"  # character sent to modem to start recv
ModemRecvFillOrder: MSB2LSB  # bit order of received facsimile
ModemSendFillOrder: LSB2MSB  # bit order modem expects for transmit
ModemWaitTimeCmd: ATS7=90  # wait 90 seconds for carrier


-----Original Message-----
From: Harlan Stenn <Harlan.Stenn@pfcs.com>
To: flexfax@sgi.com <flexfax@sgi.com>
Date: Saturday, October 03, 1998 2:05 PM
Subject: flexfax: modem config file for MultiTech mt5634zbav?


>Anybody have a working config file for a MultiTech  MT5634ZBAV?
>
>Incoming faxes won't display (the tiff files have "short" lines).
>
>H
>
>