flexfax: problems with hylafax retrying

[Eli Klein <elijah@xor.com>]

I'm getting this error (undoubtedly a pagenet specific problem) about once
in every 10 tries, when sending pages:

Sep 04 16:15:56.42: [  646]: --> [20:CONNECT 2400/ARQ/MNP]
Sep 04 16:15:56.42: [  646]: EXPECT ID (paging central identification)
Sep 04 16:15:58.42: [  646]: MODEM TIMEOUT: reading line from modem
Sep 04 16:15:58.68: [  646]: RECV ID ("ID=")
Sep 04 16:15:58.68: [  646]: SEND device identification/login request
Sep 04 16:16:00.11: [  646]: RECV ACK (login successful)
Sep 04 16:16:00.11: [  646]: RECV: Processing - Please wait
Sep 04 16:16:00.60: [  646]: RECV go-ahead (prologue done)
Sep 04 16:16:00.60: [  646]: SEND message block
Sep 04 16:16:01.37: [  646]: RECV: Bad Line - Please Call Back
Sep 04 16:16:01.37: [  646]: RECV EOT (forced disconnect)
Sep 04 16:16:01.37: [  646]: <-- [5:ATH0\r]
Sep 04 16:16:06.37: [  646]: MODEM TIMEOUT: reading line from modem
Sep 04 16:16:06.37: [  646]: MODEM <Timeout>
Sep 04 16:16:06.37: [  646]: MODEM input buffering enabled
Sep 04 16:16:06.38: [  646]: MODEM set DTR OFF
Sep 04 16:16:06.38: [  646]: SESSION END

I'm using Hylafax 4.0pl2, running on BSDi 4.0, with a USR Courier
v.everything modem.  For some reason, hylafax simply gives up at this point
(in the log above), rather than trying to redial up to the max (which I
believe is set to 12 currently).  It does however redial if the number is
busy.  Is there anyway to make hylafax redial when it gets a "forced
disconnect"?

Thanks for any help in advance

-Eli Klein
Technical Specialist
elijah@xor.com
http://www.xor.com