Re: flexfax: Unspecified Transmit Phase B error

[Ori Chalak <ori.chalak@analog.com>]

> >...
> >My configuration is: Hylafax 4.0p11, gcc v2.7, Linux, US Robotics
> >Sportster voice 33.6 Faxmodem, Ghostscript 2.6.2 (with tiffg3 driver
> >installed).
> >
> >I installed Hylafax software, got hfaxd and faxq running. Problem is
> >when I try to send a fax with send fax. Modem calls then number, begins
> >to open then connection and then disconnect the line. I got the message
> >in the xferlog file: UNSPECIFIED TRANSMIT PHASE B ERROR.
> >... 
> 
> Many people have had problems with the USR Sportster 33.6 modem. Best
> bet is to change it; but some have tried adding the following line to
> their modem config file (eg /var/spool/fax/etc/config.cua1 file) :-
> 
> Class2NRCmd:            AT+FNR=1,1,1,0      #setup status reporting command
> 
> Will you let us know if you are one of the lucky ones?
> 
> Aaah, just another thought. You could try switching to Class 1.

Hi,

  I have US-Robotics sportster Faxmodem with X2 56k. I got PHASE B ERROR.
  The above solution fixed the problem:

    Class2NRCmd:            AT+FNR=1,1,1,0      #setup status reporting command

  Thanks to the people who found this out and posted it into flexfax@sgi.com .

  I have another minor problem:

    When switching from HylaFax to PPP, PPP fail, unless I run before it tip,
    and type the reset command into it "ATZ". Does anyone know how to make HylaFax insert
    the reset command automatically upon termination ?

Thanks,

Ori Chalak