flexfax: Adaptive answer.

[Thomas Unger <unger@raindrop.seaslug.org>]

Hi again.  I'm running HylaFax 4.0 on freebsd with a ZOOM K56.

I've hooked up this modem and have started working with getting it to
work.  In hand tests it seems to do adaptive answer BUT for data mode
I need to have the following occur:

  1)  modem says "RING"
  2)  send command "ATA"
  3)  modem says "DATA"
  4)  send command "ATO"
  5)  modem says "CONNECT xxxx"

The key is to send ATO.  And I can do this by setting
"ModemAnswerDataBeginCmd: ATO".  But it leads to the following:


Oct 17 13:31:18.82: [10132]: SESSION BEGIN 00000138 12063027261
Oct 17 13:31:18.82: [10132]: <-- [4:ATA\r]
Oct 17 13:31:39.20: [10132]: --> [4:DATA]
Oct 17 13:31:39.20: [10132]: <-- [4:ATO\r]
Oct 17 13:31:40.33: [10132]: --> [14:CONNECT 115200]
Oct 17 13:32:10.34: [10132]: MODEM TIMEOUT: reading line from modem
Oct 17 13:32:10.34: [10132]: MODEM <Timeout>
Oct 17 13:32:10.35: [10132]: ANSWER: DATA CONNECTION
Oct 17 13:32:10.35: [10132]: GETTY: START "/usr/libexec/getty std.115200",
pid 10136
Oct 17 13:32:10 raindrop FaxGetty[10132]: ANSWER: DATA CONNECTION
Oct 17 13:32:10 raindrop FaxGetty[10132]: GETTY: START "/usr/libexec/getty
std.1


The modem seems to miss the "CONNECT" message.  Then it times out after
30 seconds and starts getty.  So this works but I would like to eliminate
the delay.  

Suggestions?


                                                      ooooo
 -- Tom Unger                                       oo\    oo
    Wet Weather Consulting                         o   \     o
    (206)325-7403                                 o  B I\V I  o
                                                   o     \   o
                                                    oo    \oo
                                                      ooooo