Re: squished faxes when receiving a fax

[High Mercury <merc@icanect.net>]

Glen,
   Sending it with fine mode works but I need for it to work in standard
mode too.  I'd really like to know if this is a problem with the modem or
just a configuration issue.  If it helps here is my config for one of them:

CountryCode:            1
AreaCode:              	xxx 
FAXNumber:              +1.xxx.xxx.xxxxxxx
LongDistancePrefix:     1
InternationalPrefix:    011
DialStringRules:        "etc/dialrules"
ServerTracing:          65534   
SessionTracing:         65534
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      1
SpeakerVolume:          off
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        "xxxxxxxxxxx"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%p of %%t"
MaxRecvPages:           25
#RecvDataFormat:                "1-D MR"
#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:              Class2          # use class 2 interface
ModemRate:              38400           # lock rate for DCE-DTE communication
ModemFlowControl:       rtscts          # default
#
ModemHardFlowCmd:       AT&E4           # hardware flow control
ModemSoftFlowCmd:       AT&E5           # software flow control
ModemSetupDTRCmd:       AT&D3           # setup so DTR drop resets modem
ModemSetupDCDCmd:       AT&C1           # setup so DCD reflects carrier (or not)
ModemSetupAACmd:        AT+FAA=1        # enable adaptive-answer in class 2
#
# NB: some models get confused by the @
#
ModemDialCmd:           ATDT%s@         # T for tone dialing, @ for silence
#
Class2RecvDataTrigger:  "\022"          # character sent to modem to start recv

> Merc, try sending the faxes in "high" resolution: I suspect that the
> fax systems are disagreeing about the resolution.

I haven't tried the Class2DDISCmd:  at+fdis parameter in the config file
but will try tonight to see if that works.

thanks

merc