Re: Problems with ZyXel 1496R+ (rack modem)

[Matthias.Apitz@SOFTCON.de]

Mathias Koerber wrote:
    
    Hi all,
    
    I have a problem with a Zyxel 1496R+ Rack mounted modem...
    
    I could compile, install and configure Hylafax fine. It recognises the
    modem, can talk to etc. But when I try to send to my local fax-machine,
    it dials, the fax picks up, but they don't exchange any training signals,
    and hylafax gives up after a while with NO CARRIER.
    
    I can send to the same faxmachine from an older Hylafax installation, which
    uses a standalone Zyxel 1496S modem..
    
    It seems it is either a problem with the cabling (the rackmounted Zyxels
    are connected via loose wires in the back :-(, my modem
    settings  or the firmware version..
    
    Does anyone have any hints for me???
    
    Tia
    Mathias
    
    		...
    	# 
    	ModemResetCmds:         AT&B1&N0&S0*F0S18=2S38.3=1S39=0
    	#
    	ModemDialCmd:           ATDT%s          # no '@' 'cuz then busy not recognized
    		...
    	# cat *13
    	Apr 04 14:16:49.10: [ 9653]: SESSION BEGIN 00000013 654753273
    	Apr 04 14:16:49.10: [ 9653]: SEND FAX: JOB 8 DEST +65.4753273 COMMID 00000013
    	Apr 04 14:16:49.10: [ 9653]: DELAY 2600 ms
    	Apr 04 14:16:51.71: [ 9653]: <-- [44:AT&B1&N0&S0*F0S18=2S38.3=1S39=0E0V1Q0S0=0H0\r]
    	Apr 04 14:17:23.07: [ 9653]: <-- [17:AT+FLI="SingNet"\r]
    	Apr 04 14:17:23.18: [ 9653]: --> [2:OK]
    	Apr 04 14:17:23.18: [ 9653]: DIAL 4753273@
    	Apr 04 14:17:23.18: [ 9653]: <-- [13:ATDT4753273@\r]
                                                       ^^
	....

How do you dial the "@"?

Try also upping S7 with "ModemWaitTimeCmd:        ATS7=120"

	matthias