Re: 1D/2D

["C.W.P. Schoenmakers" <cschoen@solair1.inter.NL.net>]

Hello,

Hy...ax :-)) keeps some ( and use it) knowledge about remote machines in the

(SPOOLDIR)/info directory, so remove the reference to the
target machine and resend the fax. Maybe someone changed the
faxequipement on the remote side.

regards

kees

On Wed, 5 Mar 1997, Mr. Arlington Hewes wrote:

> In message <199703050020.RAA22562@genie96.com>, Steve Williams writes:
> >
> >Here is the post that I think you are referring to....however, it only
> >mentions receiving, not sending.  From the tone of the post, it would
> >appear that Multitech is quite cooperative.  If TPC.INT has enough 
> >faxes failing consistently, you should have a bunch of log files to 
> >give them, once you find the right person to give them to.
> 
> This looks like it may be relevant . . . :
> 
> 
>     ---- Transcript of session follows ----
> 
> Mar 04 14:39:46.58: [16756]: SESSION BEGIN 00000884 44122727xxxx
> Mar 04 14:39:46.58: [16756]: SEND FAX: JOB 20661 DEST +44122727xxxx COMMID 
> 00000884
> Mar 04 14:39:46.58: [16756]: DELAY 2600 ms
> Mar 04 14:39:51.38: [16756]: <-- [15:ATE0V1X4S0=0H0\r]
> Mar 04 14:39:51.49: [16756]: --> [14:ATE0V1X4S0=0H0]
> Mar 04 14:39:51.49: [16756]: --> [2:OK]
> Mar 04 14:39:51.49: [16756]: <-- [21:ATS8=2S7=60&E4&D3&C1\r]
> Mar 04 14:39:51.59: [16756]: --> [2:OK]
> Mar 04 14:39:51.59: [16756]: <-- [12:AT+FCLASS=2\r]
> Mar 04 14:39:51.71: [16756]: --> [2:OK]
> Mar 04 14:39:51.71: [16756]: <-- [10:AT+FTBC=0\r]
> Mar 04 14:39:51.81: [16756]: --> [2:OK]
> Mar 04 14:39:51.81: [16756]: <-- [10:AT+FBOR=0\r]
> Mar 04 14:39:51.91: [16756]: --> [2:OK]
> Mar 04 14:39:51.91: [16756]: <-- [13:AT+FPHCTO=60\r]
> Mar 04 14:39:52.01: [16756]: --> [2:OK]
> Mar 04 14:39:52.01: [16756]: <-- [24:AT+FDCC=1,5,2,2,2,0,0,0\r]
> Mar 04 14:39:52.11: [16756]: --> [2:OK]
> Mar 04 14:39:52.11: [16756]: <-- [5:ATM0\r]
> Mar 04 14:39:52.21: [16756]: --> [2:OK]
> Mar 04 14:39:52.35: [16756]: <-- [12:AT+FCLASS=2\r]
> Mar 04 14:39:52.56: [16756]: --> [2:OK]
> Mar 04 14:39:52.56: [16756]: <-- [10:AT+FTBC=0\r]
> Mar 04 14:39:52.75: [16756]: --> [2:OK]
> Mar 04 14:39:52.75: [16756]: <-- [10:AT+FBOR=0\r]
> Mar 04 14:39:52.95: [16756]: --> [2:OK]
> Mar 04 14:39:52.95: [16756]: <-- [13:AT+FPHCTO=60\r]
> Mar 04 14:39:53.15: [16756]: --> [2:OK]
> Mar 04 14:39:53.15: [16756]: <-- [24:AT+FDCC=1,5,2,2,2,0,0,0\r]
> Mar 04 14:39:53.35: [16756]: --> [2:OK]
> Mar 04 14:39:53.35: [16756]: <-- [29:AT+FLID="Someone Ltd"\r]
> Mar 04 14:39:53.55: [16756]: --> [2:OK]
> Mar 04 14:39:53.57: [16756]: DIAL 0122727xxxx
> Mar 04 14:39:53.57: [16756]: <-- [16:ATDT0122727xxxx\r]
> Mar 04 14:40:16.32: [16756]: --> [5:+FCON]
> 
> Mar 04 14:40:18.35: [16756]: --> [28:+FCSI:"                    "]
> Mar 04 14:40:18.35: [16756]: REMOTE CSI ""
> Mar 04 14:40:18.35: [16756]: --> [21:+FDIS:1,5,0,2,0,0,0,0]
> Mar 04 14:40:18.35: [16756]: --> [2:OK]
> Mar 04 14:40:18.35: [16756]: REMOTE best rate 14400 bit/s
> Mar 04 14:40:18.35: [16756]: REMOTE max page width 1728 pixels in 215 mm
> Mar 04 14:40:18.35: [16756]: REMOTE max unlimited page length 
> Mar 04 14:40:18.35: [16756]: REMOTE best vres 7.7 line/mm
> Mar 04 14:40:18.35: [16756]: REMOTE best format 1-D MR
> Mar 04 14:40:18.35: [16756]: REMOTE best 0 ms/scanline
> Mar 04 14:40:18.35: [16756]: USE 14400 bit/s
> Mar 04 14:40:18.35: [16756]: USE 0 ms/scanline
> Mar 04 14:40:18.35: [16756]: SEND file "docq/doc31926.ps;41"
> Mar 04 14:40:18.38: [16756]: Document was encoded with 2DMR, but client does 
> not support this data format
> Mar 04 14:40:18.38: [16756]: <-- [5:ATH0\r]
> Mar 04 14:40:19.99: [16756]: --> [0:]
> Mar 04 14:40:19.99: [16756]: MODEM <Empty line>
> Mar 04 14:40:20.11: [16756]: SESSION END
> 
> 
> 
> -DPN
> 
>