Modem getting wedged

[Todd Knaus <todd@cis.cisnet.com>]

Dear Fellow Hylafax users,

I am new to this list so please forgive me if this topic has been covered. 

I just installed the new Hylafax v4.0pl1 on a BSDI 2.1 Unix box.  Before
doing so however I removed all references to flexfax or hylafax from BSDI
2.1.  I wanted to make sure this was a clean compile and install.

The build and install went without a hitch.  I also installed an internal
Cardinal class 2 faxmodem on tty00.  I can access the modem using tip and
can dial out on it with no problem. 

Now this is where I am getting stuck.  Sending a fax using the command:

sendfax -n -d "todd@faxnumber" -x "CISNet, Inc." -r "Test Fax" somefile

Will queue the fax up but will not send it.  Faxstat shows the fax in the
queue but I get an email message saying the modem is wedged.

Faxq is running and I am using faxmodem tty00.  The system is for outgoing
faxes only.  I will not be receiving faxes so I did not start faxgetty.

Any hints, tips, pointers, FAQ's, etc. would be greatly appreciated....

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Todd Knaus	|      CISNet, Inc.	|      Youngstown  Ohio's
Vice President	|   Internet Services	| Full Service Internet Provider
(216)629-2691 P	|-----------------------|    
(216)629-2692 F |   todd@cisnet.com   	|    http://www.cisnet.com 
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~