Re: [hylafax-users] Can cid be configured to call a program?

To: Mikhail Teterin <Mikhail.Teterin@xxxxxxxxx>
Subject: Re: [hylafax-users] Can cid be configured to call a program?
From: Aidan Van Dyk <aidan@xxxxxxxx>
Cc: hylafax-users@xxxxxxxxxxx
Date: Thu, 16 Feb 2006 22:11:47 -0500

* Mikhail Teterin <Mikhail.Teterin@xxxxxxxxx> [060216 21:19]:
 
> Is this because the RingsBeforeAnswer is set to 12? But the CID information is 
> available after the 1st or the 2nd rings, so the DynamicConfig program should 
> be invoked... I even appended the #CID=1 to every one of the Modem*Cmd lines 
> in the config.ttyd0:

Yes.  DynamicConfig is invoked only when faxgetty is ready to answer the
modem (and if RingsBeforeAnswer is 12, then it will wait for 12 rings
before it's ready to answer the modem).

a.

-- 
Aidan Van Dyk                                             aidan@xxxxxxxx
Senior Software Developer                          +1 215 438-4638 x8103
iFAX Solutions, Inc.                                http://www.ifax.com/

Attachment: signature.asc
Description: Digital signature

Follow-Ups:
- Re: [hylafax-users] Can cid be configured to call a program?
  - From: Mikhail Teterin

References:
- Re: [hylafax-users] Can cid be configured to call a program?
  - From: Mikhail Teterin

Prev by Date: Re: [hylafax-users] Hylafax Minimum Requirements
Next by Date: [hylafax-users] Hylafax Modules
Previous by thread: Re: [hylafax-users] Can cid be configured to call a program?
Next by thread: Re: [hylafax-users] Can cid be configured to call a program?
Index(es):
- Main
- Thread

Report any problems to webmaster@hylafax.org

HylaFAX is a trademark of Silicon Graphics Corporation.
Internet connectivity for hylafax.org is provided by:
VirtuALL Private Host Services