Hylafax Mailing List Archives

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

[hylafax-users] Missing EOL after 5 seconds (section 3.2/T.4)




Hi all,
many faxes are not received with the following errorcode:

Feb 09 10:40:05.51: [21823]: REMOTE HANGUP: Missing EOL after 5 seconds (section 3.2/T.4) (code 91)

who can help please ?
Best regards
Wolfgang Fürtbauer

Modem:

Feb  9 10:47:34 hylafax FaxGetty[30964]: OPEN /dev/ttyC8  HylaFAX (tm) Version 4.2.0
Feb  9 10:47:45 hylafax FaxGetty[30964]: MODEM ZYXEL Omni56K/1.01

Config:

CountryCode:                +43
AreaCode:                7665
FAXNumber:                +43-7665-8123-22
LongDistancePrefix:        0
InternationalPrefix:        0
DialStringRules:        etc/dialrules
ServerTracing:                1
SessionTracing:                11
RecvFileMode:                0600
LogFileMode:                0600
DeviceMode:                0600
RingsBeforeAnswer:        1
SpeakerVolume:                off
GettyArgs:                "-h %l dx_%s"
LocalIdentifier:        "EBEWE Pharma"
TagLineFont:                etc/lutRS18.pcf
TagLineFormat:                "From %%l|%c|Page %%P of %%T"
NoCarrierRetrys:        3
MaxRecvPages:                80
Class2RecvDataTrigger:        ``"\022"''                # a la 2388-B
Class2XmitWaitForXON:   yes             # if true, wait for XON before send
#
# Configuration parameters for Class 2 modems.
#
Class2Cmd:                AT+FCLASS=2        # command to enter class 2
Class2BORCmd:                AT+FBOR=0        # bit order for phase B/C/D (direct)
Class2RELCmd:                AT+FREL=1        # byte-align EOL codes on recv
Class2CQCmd:                ""                # commands to enable copy quality proc.
Class2AbortCmd:                AT+FK                # abort session command
Class2CQQueryCmd:        AT+FCQ=?        # query for copy quality capabilities
Class2DCCQueryCmd:        AT+FDCC=?        # query for modem capabilities
Class2TBCCmd:                AT+FTBC=0        # setup stream mode
Class2CRCmd:                AT+FCR=1        # enable capability to receive
Class2PHCTOCmd:                AT+FPHCTO=30        # set phase C timeout parameter
Class2BUGCmd:                AT+FBUG=1        # enable HDLC frame tracing
Class2LIDCmd:                AT+FLID                # set local identifier command
Class2DCCCmd:                AT+FDCC                # set modem capabilities command
Class2DISCmd:                AT+FDIS                # set session parameters command
Class2DDISCmd:                ""                # disable pre-dial DIS command hack
Class2CIGCmd:                AT+FCIG                # set polling identifier command
Class2PTSCmd:                AT+FPTS                # set post-page status command
Class2SPLCmd:                AT+FSPL                # set polling indicator command
#
# If Class2RecvDataTrigger is not set, then it is set to DC1
#
#Class2RecvDataTrigger:        ""                # character sent to modem to start recv
#Class2XmitWaitForXON:        yes                # if true, wait for XON before send


Log:

Feb 09 10:38:49.75: [21823]: SESSION BEGIN 000019343 437665812311
Feb 09 10:38:49.75: [21823]: HylaFAX (tm) Version 4.2.0
Feb 09 10:38:49.75: [21823]: <-- [4:ATA\r]
Feb 09 10:38:59.60: [21823]: --> [5:+FCON]
Feb 09 10:38:59.60: [21823]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyC8'
Feb 09 10:38:59.60: [21823]: RECV FAX: begin
Feb 09 10:38:59.60: [21823]: RECV FAX: CDPN
Feb 09 10:38:59.85: [21823]: --> [28:+FTSI:"         06181354302"]
Feb 09 10:38:59.85: [21823]: REMOTE TSI "06181354302"
Feb 09 10:38:59.85: [21823]: --> [21:+FDCS:0,5,0,2,1,0,0,1]
Feb 09 10:38:59.85: [21823]: REMOTE wants 14400 bit/s
Feb 09 10:38:59.85: [21823]: REMOTE wants A4 page width (215 mm)
Feb 09 10:38:59.85: [21823]: REMOTE wants unlimited page length
Feb 09 10:38:59.85: [21823]: REMOTE wants 3.85 line/mm
Feb 09 10:38:59.85: [21823]: REMOTE wants 2-D MR
Feb 09 10:38:59.85: [21823]: --> [2:OK]
Feb 09 10:38:59.85: [21823]: <-- [7:AT+FDR\r]
Feb 09 10:39:04.17: [21823]: --> [5:+FCFR]
Feb 09 10:39:05.13: [21823]: --> [21:+FDCS:0,5,0,2,1,0,0,1]
Feb 09 10:39:05.13: [21823]: REMOTE wants 14400 bit/s
Feb 09 10:39:05.13: [21823]: REMOTE wants A4 page width (215 mm)
Feb 09 10:39:05.13: [21823]: REMOTE wants unlimited page length
Feb 09 10:39:05.13: [21823]: REMOTE wants 3.85 line/mm
Feb 09 10:39:05.13: [21823]: REMOTE wants 2-D MR
Feb 09 10:39:05.13: [21823]: --> [7:CONNECT]
Feb 09 10:39:05.13: [21823]: RECV: begin page
Feb 09 10:39:05.13: [21823]: RECV: send trigger 0140
Feb 09 10:39:05.13: [21823]: Copy quality checking performed by host
Feb 09 10:40:05.51: [21823]: RECV: Missing EOL after 5 seconds
Feb 09 10:40:05.51: [21823]: REMOTE HANGUP: Missing EOL after 5 seconds (section 3.2/T.4) (code 91)
Feb 09 10:40:05.51: [21823]: RECV FAX (000019343): recvq/fax000013195.tif from 06181354302, route to <unspecified>, 0 pages in 1:06
Feb 09 10:40:05.51: [21823]: RECV FAX: Missing EOL after 5 seconds (section 3.2/T.4)
Feb 09 10:40:05.51: [21823]: <-- [6:AT+FK\r]
Feb 09 10:40:35.51: [21823]: MODEM <Timeout>
Feb 09 10:40:35.51: [21823]: RECV FAX (000019343): session with 06181354302 terminated abnormally: Missing EOL after 5 seconds (section 3.2/T.4)
Feb 09 10:40:35.51: [21823]: RECV FAX: bin/faxrcvd "recvq/fax000013195.tif" "ttyC8" "000019343" "Missing EOL after 5 seconds (section 3.2/T.4)" "" "" ""
Feb 09 10:40:35.51: [21823]: RECV FAX: end
Feb 09 10:40:35.51: [21823]: SESSION END


----------------------------------------------------------------------
Wolfgang Fuertbauer (e-Mail: Wolfgang.Fuertbauer@xxxxxxxxx)
EBEWE Pharma
Mondseestrasse 11
4866 Unterach, Austria
Tel +43 7665 8123 315 Mobile: +43 664 8397987
Fax +43 7665 8123 1487
http://www.ebewe.com


Home
Report any problems to webmaster@hylafax.org

HylaFAX is a trademark of Silicon Graphics Corporation.
Internet connectivity for hylafax.org is provided by:
VirtuALL Private Host Services