[hylafax-users] how to setup/drive more than one same PCI modem together?

[Kite Lau <kitelau@xxxxxxxxx>]

Sorry that this is actually not a question for hylafax, but for the
modems it uses.

I have an intel 536ep based pci modem. It works fine with official
driver from intel. After driver installation, I do the following to
setup device name.

================================
insmod -f /lib/modules/2.6.10/kernel/drivers/char/Intel536.ko
mknod /dev/536ep c 240 1
================================



The device to be used is /dev/536ep then.

My question is: If I need to setup more than one same modem under ONE
system (so that I can get the best out of hylafax :)), what steps should
I take to create the corresponding devices correctly? Perhaps I need
only to change the parameter of mknod? If yes, what decides the correct
parameter? I think users on this list should counter the same question,
but I cannot find the answer from the mailinglist archive.

Any pointer will be helpful to me.

Thanks.

Kite


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*