Thanks for your response. We've sent 100 page faxes to them before
with our brother fax machine without a problem. This appears to be
related to either hylafax, the modem, or both. Generally speaking,
the Canon may simply not communicate well with my hylafax/modem
combination.
I'm just wondering if anyone else has faced a similar problem and if
you were able to overcome it.
On 8/30/05, Lee Howard <faxguy@xxxxxxxxxxxxxxxx> wrote:
Jack Liu wrote:
Hi. We're using hylafax 4.2.1 running on gentoo. Today was our
first
attempt at sending out a large (60 pages) fax to one of our vendors
who apparently uses Canon Laser 9000 Series fax machines. At around
page 41, the fax will stop with the following:
Aug 30 19:48:05.91: [ 2071]: SEND send PPS (partial page signal)
Aug 30 19:48:05.91: [ 2071]: SEND send MPS (more pages, same
document)
Aug 30 19:48:05.91: [ 2071]: <-- [9:AT+FRH=3\r]
Aug 30 19:48:06.36: [ 2071]: --> [7:CONNECT]hylafax-
users@xxxxxxxxxxx
Aug 30 19:48:07.25: [ 2071]: --> [2:OK]
Aug 30 19:48:07.25: [ 2071]: SEND recv DCN (disconnect)
Does the receiver have a limit on the number of pages that they can
receive? Did they run out of paper? Is it trying to store the whole
thing in memory and the memory fills up?
In any case the answer to what is happening has to come from the
receiver. It is the one sending the DCN signal. Of course the
operator
of the receiver may not know why it's doing that.
Lee.
