Re: [hylafax-users] Half page problem, possible training issue

[Lee Howard <faxguy@xxxxxxxxxxxxxxxx>]

Dan Rowe wrote:

> One Monday mornings we send out 700-800 faxes
>
> Only one faxmachine on the receiving end has problems. It's an IntelliFax
> 4100.
>
> Attached is the Log file of a half page transaction.
> Here is the completed email I get that says the fax went fine. 
>
> Pages: 1
> Receiver: {phonenumber}
> Quality: Normal
> Page Width: 215 (mm)
> Page Length: 279 (mm)
> Signal Rate: 2400 bit/s
> Data Format: 2-D MMR
> Remote Equipment: Brother
> Remote Station: 
> Submitted From: localhost
> JobID: 11102
> GroupID: 11102
> CommID: c000002176
> Processing time was 2:12.
>
> Thanks for any help, info.
>  

It's very difficult to say why this receiver would only succeed in 
training at 2400 baud.  If I were to speculate, I'd say that the 
receiver's fax machine is configured that way (like there is a setting 
or something where they can turn down the accepted baud rates).

The log doesn't indicate enough noise to justify so many training 
failures, and the log doesn't indicate that there are particular 
modulator incompatibilities, either.  So it would pretty much seem that 
the receiver either has some bug or some feature that is causing this to 
happen.

But, like I said, it's very difficult to say.

Lee.


____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*