[hylafax-users] Wrong fax number used after a "No carrier detected" error

[erich.iseli@xxxxxxxxxxxxxxxx]

Hello,

I've already posted this problem before
(http://www.hylafax.org/archive/2005-06/msg00098.html
<http://www.hylafax.org/archive/2005-06/msg00098.html> ) but in the mean
time I've found out more: Whenever the modem detects no carrier and the
communication lasts 0:01 to 0:02 (1-2 seconds), the following fax will go
out to the number where no carrier was detected. See the transcripts below.
Note that hylafax thinks it's sending to the right number, but the remote
fax shows through ist CSI that it's clearly not the case.

Now I've noticed that there are 2 kinds of "no carrier detected": one when
there's no tone on the line (that would be the case if the communication
lasts 1-2 seconds) and one when the modem dials but the fax is answered by a
human and doesn't communicate with the caller fax, then hangs up. In this
case, my logs show that the communication usually lasts about 20 seconds.

So now I'm wondering: why would the modem get no dial tone? I don't know
about our phone line, but I've never picked up the phone without getting a
tone. So that should be the same with the faxmodem.

And also: why would the modem remember the previous phone number instead of
dialling the new one? Doesn't it listen to the commands sent by hylafax? Is
there a way to reset the modem through hylafax, whenever it begins a new
session?

Thanks for your insights,

Erich


P.S. Our Modem is an ELSA MicroLink ISDN/TL V.34






Jun 14 08:58:44.63: [20993]: SESSION BEGIN 000009983 41123456789
Jun 14 08:58:44.63: [20993]: HylaFAX (tm) Version 4.2.0
Jun 14 08:58:44.63: [20993]: SEND FAX: JOB 9077 DEST 0123456789 COMMID
000009983 DEVICE '/dev/ttyS0'
Jun 14 08:58:44.63: [20993]: <-- [9:AT+FLO=1\r]
Jun 14 08:58:44.78: [20993]: --> [2:OK]
Jun 14 08:58:44.78: [20993]: <-- [9:AT+FPP=0\r]
Jun 14 08:58:44.93: [20993]: --> [2:OK]
Jun 14 08:58:44.93: [20993]: <-- [9:AT+FBO=0\r]
Jun 14 08:58:45.08: [20993]: --> [2:OK]
Jun 14 08:58:45.08: [20993]: <-- [10:AT+FCT=30\r]
Jun 14 08:58:45.23: [20993]: --> [2:OK]
Jun 14 08:58:45.23: [20993]: <-- [15:AT+FNR=1,1,1,1\r]
Jun 14 08:58:45.38: [20993]: --> [2:OK]
Jun 14 08:58:45.38: [20993]: <-- [9:AT+FIE=0\r]
Jun 14 08:58:45.53: [20993]: --> [2:OK]
Jun 14 08:58:45.53: [20993]: <-- [23:AT+FCC=1,5,2,2,0,0,0,0\r]
Jun 14 08:58:45.68: [20993]: --> [2:OK]
Jun 14 08:58:45.68: [20993]: DIAL 0123456789
Jun 14 08:58:45.68: [20993]: <-- [15:ATDT0123456789\r]
Jun 14 08:58:45.87: [20993]: --> [10:NO CARRIER]
Jun 14 08:58:45.87: [20993]: SEND FAILED: JOB 9077 DEST 0123456789 ERR No
carrier detected
Jun 14 08:58:45.87: [20993]: <-- [5:ATH0\r]
Jun 14 08:58:45.99: [20993]: --> [2:OK]
Jun 14 08:58:45.99: [20993]: SESSION END
===================================
Jun 14 08:58:58.06: [21136]: SESSION BEGIN 000009984 4198765432
Jun 14 08:58:58.06: [21136]: HylaFAX (tm) Version 4.2.0
Jun 14 08:58:58.06: [21136]: SEND FAX: JOB 9079 DEST 098765432 COMMID
000009984 DEVICE '/dev/ttyS0'
Jun 14 08:58:58.06: [21136]: <-- [9:AT+FLO=1\r]
Jun 14 08:58:58.22: [21136]: --> [2:OK]
Jun 14 08:58:58.22: [21136]: <-- [9:AT+FPP=0\r]
Jun 14 08:58:58.36: [21136]: --> [2:OK]
Jun 14 08:58:58.36: [21136]: <-- [9:AT+FBO=0\r]
Jun 14 08:58:58.50: [21136]: --> [2:OK]
Jun 14 08:58:58.50: [21136]: <-- [10:AT+FCT=30\r]
Jun 14 08:58:58.64: [21136]: --> [2:OK]
Jun 14 08:58:58.64: [21136]: <-- [15:AT+FNR=1,1,1,1\r]
Jun 14 08:58:58.79: [21136]: --> [2:OK]
Jun 14 08:58:58.79: [21136]: <-- [9:AT+FIE=0\r]
Jun 14 08:58:58.94: [21136]: --> [2:OK]
Jun 14 08:58:58.94: [21136]: <-- [23:AT+FCC=1,5,2,2,0,0,0,0\r]
Jun 14 08:58:59.10: [21136]: --> [2:OK]
Jun 14 08:58:59.10: [21136]: DIAL 098765432
Jun 14 08:58:59.10: [21136]: <-- [15:ATDT098765432\r]
Jun 14 08:59:17.13: [21136]: --> [4:+FCO]
Jun 14 08:59:20.52: [21136]: --> [53:+FNF: 00 00 66 01 10 0B B2 6A 10 00 00
00 00 00 00 24]
Jun 14 08:59:20.52: [21136]: REMOTE NSF " 00 00 66 01 10 0B B2 6A 10 00 00
00 00 00 00 24"
Jun 14 08:59:20.52: [21136]: NSF remote fax equipment: Utax/Mita 
Jun 14 08:59:20.66: [21136]: --> [83:+FNF: 00 00 66 02 15 4E 4F 4B 49 46 46
45 41 46 50 20 47 41 20 52 45 52 45 48 43 53]
Jun 14 08:59:20.66: [21136]: REMOTE NSF " 00 00 66 02 15 4E 4F 4B 49 46 46
45 41 46 50 20 47 41 20 52 45 52 45 48 43 53"
Jun 14 08:59:20.66: [21136]: NSF remote fax equipment: Utax/Mita 
Jun 14 08:59:20.66: [21136]: NSF remote station ID: "ABC"
Jun 14 08:59:20.66: [21136]: --> [27:+FCI:"    +41 12 345 67 89"]
Jun 14 08:59:20.66: [21136]: REMOTE CSI "+41 12 345 67 89"
(...)


Mit freundlichen Grüssen - kind regards - Meilleures salutations -
Vriendelijke groeten

Erich Iseli

VETROTECH SAINT-GOBAIN INTERNATIONAL AG
3000 Bern 22  -  Stauffacher Str. 128 
Tel: +41 (0) 31 336 81 08
Fax: +41 (0) 31 336 81 98
mailto: Erich.Iseli@xxxxxxxxxxxxxxxx <mailto:Erich.Iseli@xxxxxxxxxxxxxxxx>  


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*