Re: [hylafax-users] Multitech 2834ZDXB US/External - not reporting "no answer"

["Glen B" <webmaster@xxxxxxxxxxxx>]

No, I was using data mode. I would've typed the fax setup commands in the
config file, but I expected them to be correct and assumed it was a firmware
problem or faxsend issue. I'll try calling in fax mode, using the commands
in my config.

Thanks,

Glen

-----Original Message-----
From: Sebastian Flothow [mailto:lists@xxxxxxxxxx]
Sent: Wednesday, June 16, 2004 9:01 AM
To: Glen B
Cc: hylafax-users@xxxxxxxxxxx
Subject: Re: [hylafax-users] Multitech 2834ZDXB US/External - not
reporting "no answer"


Am 11. Jun 2004 um 15:50 Uhr schrieb Glen B:
>   I used minicom to dial my office phone and let it ring. The modem
> eventually times out after a large number of rings and responds with NO
> CARRIER. Shouldn't faxsend be picking that up and stopping the job? I
> know
> it should respond with NO ANSWER and I'll check that out. Regardless,
> the
> modem is sending an error response that faxsend is ignoring.

I've never seen faxsend ignore incoming data (unless flow control isn't
setup properly). Did you run the modem in fax mode when dialing with
minicom?


Sebastian

--
Sebastian Flothow
sebastian@xxxxxxxxxx

Because it reverses the logical flow of conversation.
 > Why is top posting frowned upon?


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*