Re: [hylafax-users] Input overruns

["Erick Thompson" <ethompson@nbr.org>]

> On 2002.07.10 17:08 Erick Thompson wrote:
>
> > I ordered a new modem and installed it this afternoon. The modem is a
> > MT5634ZPX ISA. The modem is setup to run COM2 on IRQ3 (the same setting
> > as
> > the previous modem).
>
> COM2, eh?  Running WinDoS?  Not ttyS1?  ;-)

Oh yeah, I guess it would be ttyS1 :)

> > After installation, I started to get "TTYS: x: input
> > overrun(s)" on the console. X could be between 1 and 300. When I send a
> > fax,
> > I get a number of these messages. However, the test faxes that I have
> > tried
> > are sent without any problems. Should I ignore these messages?
>
> This usually happens when there are IRQ conflicts or there is
> mis-configured hardware.  Check to make sure that you do not have a ttyS3
> (COM4) enabled either on the motherboard or by another serial device.  You
> don't want anything else using IRQ3.

I went into the config.modem file and changed the flow control to ctsrts
(hardware). This seemed to resolve the problem.

Thanks,
Erick


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null