Hi !
i'm experiencing a problem on the installation of
the Hylafax Server.
That's my configuration :
Linux Mandrake 8.1
Modem Dynalink 1414 VQE (but
i've tried with 3 differents modems)
Hylafax 4.1.1
WHFC v 1.0.8
After my installation, i've done a test, the fax
sendind from the server
(the fax-client of mandrake) worked without any
problem.
On the other hand it is impossible for me to send a fax from a
computer in the local area network !
When I sendings the fax (with the
fax-client WHFC) the modem (connected on the serv port com1) answers well,
it
dial the fax number, but at the time of sending data the communication is
suddenly interrupted.
I give you the part of the log where is the error :
avr 10 10:37:50.76: [12039]: DIAL 0479258929
avr
10 10:37:50.76: [12039]: <-- [15:ATDT0479258929\r]
avr 10 10:38:16.66:
[12039]: --> [5:+FCON]
avr 10 10:38:18.80: [12039]: --> [29:+FCSI: " 33
04 79251106 "]
avr 10 10:38:18.80: [12039]: REMOTE
CSI "33 04 79251106"
avr 10 10:38:19.17: [12039]: --> [22:+FDIS:
1,3,2,2,0,0,0,0]
avr 10 10:38:19.28: [12039]: --> [2:OK]
avr 10
10:38:19.28: [12039]: REMOTE best rate 9600 bit/s
avr 10 10:38:19.28:
[12039]: REMOTE max page width 2432 pixels in 303 mm
avr 10 10:38:19.28:
[12039]: REMOTE max unlimited page length
avr 10 10:38:19.28: [12039]: REMOTE
best vres 7.7 line/mm
avr 10 10:38:19.28: [12039]: REMOTE best format 1-D
MR
avr 10 10:38:19.28: [12039]: REMOTE best 0 ms/scanline
avr 10
10:38:19.28: [12039]: USE 9600 bit/s
avr 10 10:38:19.28: [12039]: USE 0
ms/scanline
avr 10 10:38:19.28: [12039]: <-- [5:ATH0\r]
avr 10
10:38:19.53: [12039]: --> [9:+FHNG: 20]
avr 10 10:38:19.53: [12039]:
REMOTE HANGUP: Unspecified Transmit Phase B error (code 20)
avr 10
10:38:20.51: [12039]: --> [2:OK]
avr 10 10:38:20.51: [12039]: SESSION END
I've also tried with 2 different fax-number without
any results...
Could you help me please ? it is very important for my job
!
Best Regards.
Ps : Excuse my poor language but i'm french
:)
