|
Hylafax Mailing List Archives
|
[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index]
[Thread Index]
Re: [hylafax-users] Sedlbauer ISDN card
Lee Howard <faxguy@deanox.com> worte on Donnerstag, 16. August 2001:
> [...]
> Please turn SessionTracing to 0xFFF and resend a new log.
Here it is.
The lines
Aug 16 17:51:39.93: [ 5012]: <-- [10:AT+FRM=96\r]
Aug 16 17:51:43.34: [ 5012]: --> [7:FCERROR]
seem to suggest something goes wrong. Possibly this has to do with the
fact that this - really old - fax machine has to do with polling in
the next sheet and the hylafax (or the isdn modem emulation) expects a
somewhat quicker peer?
Thanks, Moritz
recvq/fax00028.tif:
Sender: +49 511 713496
Pages: 1
Quality: Normal
Page: ISO A4
Received: 2001:08:16 17:51:01
TimeToRecv: 0:38
SignalRate: 9600 bit/s
DataFormat: 1-D MR
The full document was not received because:
T.30 T2 timeout, expected page not received
---- Transcript of session follows ----
Aug 16 17:50:47.90: [ 5012]: SESSION BEGIN 00000026 4951127041633
Aug 16 17:50:47.90: [ 5012]: MODEM set XON/XOFF/FLUSH: input ignored, output disabled
Aug 16 17:50:47.90: [ 5012]: <-- [4:ATA\r]
Aug 16 17:50:53.09: [ 5012]: --> [7:CONNECT]
Aug 16 17:50:53.09: [ 5012]: ANSWER: FAX CONNECTION
Aug 16 17:50:53.09: [ 5012]: STATE CHANGE: ANSWERING -> RECEIVING
Aug 16 17:50:53.09: [ 5012]: MODEM input buffering enabled
Aug 16 17:50:53.09: [ 5012]: RECV FAX: begin
Aug 16 17:50:53.09: [ 5012]: MODEM input buffering disabled
Aug 16 17:50:53.09: [ 5012]: <-- HDLC<23:FF C0 02 26 76 AE 04 B4 76 A6 2E 86 22 04 76 86 4E 86 46 A6 26 36 82>
Aug 16 17:50:53.09: [ 5012]: <-- data [23]
Aug 16 17:50:53.09: [ 5012]: <-- data [2]
Aug 16 17:50:53.14: [ 5012]: --> [7:CONNECT]
Aug 16 17:50:53.14: [ 5012]: <-- HDLC<10:FF C8 01 00 77 5F 01 79 03 C0>
Aug 16 17:50:53.14: [ 5012]: <-- data [10]
Aug 16 17:50:53.14: [ 5012]: <-- data [2]
Aug 16 17:50:54.25: [ 5012]: --> [2:OK]
Aug 16 17:50:54.25: [ 5012]: <-- [9:AT+FRH=3\r]
Aug 16 17:50:54.62: [ 5012]: --> [7:CONNECT]
Aug 16 17:50:56.20: [ 5012]: --> HDLC<25:FF C0 C2 6C 9C 2C CC 8C EC 04 8C 8C AC 04 9C 2C D4 04 04 04 04 04 04 D4 61>
Aug 16 17:50:56.20: [ 5012]: --> [2:OK]
Aug 16 17:50:56.20: [ 5012]: REMOTE TSI "+49 511 713496"
Aug 16 17:50:56.20: [ 5012]: <-- [9:AT+FRH=3\r]
Aug 16 17:50:56.21: [ 5012]: --> [7:CONNECT]
Aug 16 17:50:56.53: [ 5012]: --> HDLC<8:FF C8 C1 00 60 14 08 4A>
Aug 16 17:50:56.53: [ 5012]: --> [2:OK]
Aug 16 17:50:56.53: [ 5012]: REMOTE wants 9600 bit/s
Aug 16 17:50:56.53: [ 5012]: REMOTE wants page width 1728 pixels in 215 mm
Aug 16 17:50:56.53: [ 5012]: REMOTE wants unlimited page length
Aug 16 17:50:56.53: [ 5012]: REMOTE wants 3.85 line/mm
Aug 16 17:50:56.53: [ 5012]: REMOTE wants 1-D MR
Aug 16 17:50:56.53: [ 5012]: RECV training at v.29 9600 bit/s
Aug 16 17:50:56.53: [ 5012]: MODEM set XON/XOFF/DRAIN: input ignored, output generated
Aug 16 17:50:56.53: [ 5012]: <-- [10:AT+FRM=96\r]
Aug 16 17:50:56.90: [ 5012]: --> [7:CONNECT]
Aug 16 17:50:58.49: [ 5012]: MODEM set XON/XOFF/DRAIN: input ignored, output disabled
Aug 16 17:50:58.49: [ 5012]: RECV: TCF 1912 bytes, 5% non-zero, 1809 zero-run
Aug 16 17:50:58.49: [ 5012]: --> [10:NO CARRIER]
Aug 16 17:50:58.49: [ 5012]: DELAY 75 ms
Aug 16 17:50:58.57: [ 5012]: <-- [9:AT+FTH=3\r]
Aug 16 17:51:00.21: [ 5012]: --> [7:CONNECT]
Aug 16 17:51:00.21: [ 5012]: <-- HDLC<3:FF C8 21>
Aug 16 17:51:00.21: [ 5012]: <-- data [3]
Aug 16 17:51:00.21: [ 5012]: <-- data [2]
Aug 16 17:51:00.46: [ 5012]: --> [2:OK]
Aug 16 17:51:00.46: [ 5012]: TRAINING succeeded
Aug 16 17:51:00.46: [ 5012]: MODEM input buffering enabled
Aug 16 17:51:00.46: [ 5012]: MODEM set XON/XOFF/FLUSH: input ignored, output generated
Aug 16 17:51:00.46: [ 5012]: <-- [10:AT+FRM=96\r]
Aug 16 17:51:01.73: [ 5012]: --> [7:CONNECT]
Aug 16 17:51:01.73: [ 5012]: RECV: begin page
Aug 16 17:51:38.60: [ 5012]: RECV/CQ: Bad 1D pixel count, row 1158, got 0, expected 1728
Aug 16 17:51:38.60: [ 5012]: RECV/CQ: Bad 1D pixel count, row 1159, got 0, expected 1728
Aug 16 17:51:38.60: [ 5012]: RECV/CQ: Bad 1D pixel count, row 1160, got 0, expected 1728
Aug 16 17:51:38.60: [ 5012]: RECV/CQ: Bad 1D pixel count, row 1161, got 0, expected 1728
Aug 16 17:51:38.60: [ 5012]: RECV/CQ: Bad 1D pixel count, row 1162, got 0, expected 1728
Aug 16 17:51:38.60: [ 5012]: RECV/CQ: Adjusting for RTC found at row 1157
Aug 16 17:51:38.60: [ 5012]: RECV: 1157 total lines, 0 bad lines, 0 consecutive bad lines
Aug 16 17:51:38.60: [ 5012]: RECV: end page
Aug 16 17:51:38.60: [ 5012]: --> [10:NO CARRIER]
Aug 16 17:51:38.60: [ 5012]: MODEM set XON/XOFF/DRAIN: input ignored, output disabled
Aug 16 17:51:38.60: [ 5012]: MODEM input buffering disabled
Aug 16 17:51:38.60: [ 5012]: <-- [9:AT+FRH=3\r]
Aug 16 17:51:38.71: [ 5012]: --> [7:CONNECT]
Aug 16 17:51:39.78: [ 5012]: --> HDLC<5:FF C8 F2 AC A0>
Aug 16 17:51:39.78: [ 5012]: --> [2:OK]
Aug 16 17:51:39.78: [ 5012]: RECV recv MPS (more pages, same document)
Aug 16 17:51:39.78: [ 5012]: DELAY 150 ms
Aug 16 17:51:39.93: [ 5012]: <-- [9:AT+FTH=3\r]
Aug 16 17:51:39.93: [ 5012]: --> [10:NO CARRIER]
Aug 16 17:51:39.93: [ 5012]: RECV send MCF (message confirmation)
Aug 16 17:51:39.93: [ 5012]: RECV FAX (00000026): from +49 511 713496, page 1 in 0:39, INF, 3.85 line/mm, 1-D MR, 9600 bit/s
Aug 16 17:51:39.93: [ 5012]: MODEM input buffering enabled
Aug 16 17:51:39.93: [ 5012]: MODEM set XON/XOFF/FLUSH: input ignored, output generated
Aug 16 17:51:39.93: [ 5012]: <-- [10:AT+FRM=96\r]
Aug 16 17:51:43.34: [ 5012]: --> [7:FCERROR]
Aug 16 17:51:43.34: [ 5012]: MODEM set XON/XOFF/DRAIN: input ignored, output disabled
Aug 16 17:51:43.34: [ 5012]: MODEM input buffering disabled
Aug 16 17:51:43.34: [ 5012]: RECV FAX (00000026): recvq/fax00028.tif from +49 511 713496, route to <unspecified>, 1 pages in 0:50
Aug 16 17:51:43.34: [ 5012]: RECV FAX: T.30 T2 timeout, expected page not received
Aug 16 17:51:43.34: [ 5012]: <-- [9:AT+FTH=3\r]
Aug 16 17:51:44.98: [ 5012]: --> [7:CONNECT]
Aug 16 17:51:44.98: [ 5012]: <-- HDLC<3:FF C8 5F>
Aug 16 17:51:44.98: [ 5012]: <-- data [3]
Aug 16 17:51:44.98: [ 5012]: <-- data [2]
Aug 16 17:51:45.23: [ 5012]: --> [2:OK]
Aug 16 17:51:45.23: [ 5012]: MODEM input buffering enabled
Aug 16 17:51:45.23: [ 5012]: RECV FAX (00000026): session with +49 511 713496 terminated abnormally: T.30 T2 timeout, expected page not received
Aug 16 17:51:45.23: [ 5012]: RECV FAX: bin/faxrcvd "recvq/fax00028.tif" "ttyI0" "00000026" "T.30 T2 timeout, expected page not received"
____________________ HylaFAX(tm) Users Mailing List _______________________
To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
