[hylafax-users] send fax small image problem

To: hylafax-users@hylafax.org
Subject: [hylafax-users] send fax small image problem
From: Carolyn Mercer <cmercer@industrialhouse.com>
Date: Sat, 11 Aug 2001 12:35:43 -0400


I have a Sharp UX-1000 fax machine I'm using to test sendfax.
I'm assuming that it is a representative enough fax machine,  I expect
that if I can receive on it I can send most anywhere.

Is this correct?


Now here's the problem:
The fax that is recieved is smaller, by about 25%, than the
original PS file. This is small enough to make it unreadable. How can I
fix this?

The fax machine also registers an line err every time a page is
received.

Also, strangely enough, the FLID string sent by HylaFax is missing its
first 4-5 chars.
Does this indicate a transmission err?

Here's a typical log:

Aug 11 11:34:53.88: [15277]: SESSION BEGIN 00000531 12166718565
Aug 11 11:34:53.88: [15277]: SEND FAX: JOB 41 DEST 6718565 COMMID
00000531
Aug 11 11:34:53.88: [15277]: DELAY 2600 ms
Aug 11 11:34:56.48: [15277]: <-- [4:ATZ\r]
Aug 11 11:34:56.76: [15277]: -->
[141:ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿOATZ]

Aug 11 11:34:56.76: [15277]: --> [2:OK]
Aug 11 11:34:56.76: [15277]: <-- [15:ATE0V1Q0S0=0H0\r]
Aug 11 11:34:56.79: [15277]: --> [14:ATE0V1Q0S0=0H0]
Aug 11 11:34:56.79: [15277]: --> [2:OK]
Aug 11 11:34:56.79: [15277]: <-- [21:ATS8=2S7=60&K3&D3&C1\r]
Aug 11 11:34:56.80: [15277]: --> [2:OK]
Aug 11 11:34:56.80: [15277]: <-- [12:AT+FCLASS=2\r]
Aug 11 11:34:56.81: [15277]: --> [2:OK]
Aug 11 11:34:56.81: [15277]: <-- [10:AT+FTBC=0\r]
Aug 11 11:34:56.82: [15277]: --> [2:OK]
Aug 11 11:34:56.82: [15277]: <-- [10:AT+FBOR=0\r]
Aug 11 11:34:56.83: [15277]: --> [2:OK]
Aug 11 11:34:56.83: [15277]: <-- [13:AT+FPHCTO=30\r]
Aug 11 11:34:56.84: [15277]: --> [2:OK]
Aug 11 11:34:56.84: [15277]: <-- [24:AT+FDCC=1,5,0,2,0,0,0,0\r]
Aug 11 11:34:56.85: [15277]: --> [2:OK]
Aug 11 11:34:56.85: [15277]: <-- [5:ATM0\r]
Aug 11 11:34:56.86: [15277]: --> [2:OK]
Aug 11 11:34:56.86: [15277]: <-- [12:AT+FCLASS=2\r]
Aug 11 11:34:56.97: [15277]: --> [2:OK]
Aug 11 11:34:56.97: [15277]: <-- [10:AT+FTBC=0\r]
Aug 11 11:34:57.08: [15277]: --> [2:OK]
Aug 11 11:34:57.08: [15277]: <-- [10:AT+FBOR=0\r]
Aug 11 11:34:57.19: [15277]: --> [2:OK]
Aug 11 11:34:57.19: [15277]: <-- [13:AT+FPHCTO=30\r]
Aug 11 11:34:57.30: [15277]: --> [2:OK]
Aug 11 11:34:57.30: [15277]: <-- [24:AT+FDCC=1,5,0,2,0,0,0,0\r]
Aug 11 11:34:57.41: [15277]: --> [2:OK]
Aug 11 11:34:57.41: [15277]: <-- [27:AT+FLID="Industrial House"\r]
Aug 11 11:34:57.52: [15277]: --> [2:OK]
Aug 11 11:34:57.52: [15277]: <-- [24:AT+FDIS=1,5,0,2,0,0,0,0\r]
Aug 11 11:34:57.63: [15277]: --> [2:OK]
Aug 11 11:34:57.63: [15277]: DIAL 6718565
Aug 11 11:34:57.63: [15277]: <-- [12:ATDT6718565\r]
Aug 11 11:35:26.49: [15277]: --> [5:+FCON]
Aug 11 11:35:26.49: [15277]: -->
[71:+FNSF:0,0,49,0,206,184,196,128,17,133,13,221,0,0,221,221,0,0,221,221,0,]

Aug 11 11:35:26.49: [15277]: REMOTE NSF
"0,0,49,0,206,184,196,128,17,133,13,221,0,0,221,221,0,0,221,221,0,"
Aug 11 11:35:26.49: [15277]: NSF remote fax equipment: unknown
Aug 11 11:35:26.49: [15277]: --> [34:0,0,0,0,0,0,0,237,34,176,0,0,164,0]

Aug 11 11:35:27.21: [15277]: --> [28:+FCSI:"        216 671 5787"]
Aug 11 11:35:27.21: [15277]: REMOTE CSI "216 671 5787"
Aug 11 11:35:27.56: [15277]: --> [21:+FDIS:1,3,0,2,0,0,0,4]
Aug 11 11:35:27.56: [15277]: --> [2:OK]
Aug 11 11:35:27.56: [15277]: REMOTE best rate 9600 bit/s
Aug 11 11:35:27.56: [15277]: REMOTE max page width 1728 pixels in 215 mm

Aug 11 11:35:27.56: [15277]: REMOTE max unlimited page length
Aug 11 11:35:27.56: [15277]: REMOTE best vres 7.7 line/mm
Aug 11 11:35:27.56: [15277]: REMOTE best format 1-D MR
Aug 11 11:35:27.56: [15277]: REMOTE best 20 ms, 10 ms/scanline
Aug 11 11:35:27.56: [15277]: USE 9600 bit/s
Aug 11 11:35:27.56: [15277]: USE 20 ms, 10 ms/scanline
Aug 11 11:35:27.56: [15277]: SEND file "docq/doc63.ps;01"
Aug 11 11:35:27.56: [15277]: USE page width 1728 pixels in 215 mm
Aug 11 11:35:27.56: [15277]: USE unlimited page length
Aug 11 11:35:27.56: [15277]: USE 7.7 line/mm
Aug 11 11:35:27.56: [15277]: USE 1-D MR
Aug 11 11:35:27.56: [15277]: <-- [24:AT+FDIS=1,3,0,2,0,0,0,4\r]
Aug 11 11:35:27.67: [15277]: --> [2:OK]
Aug 11 11:35:27.67: [15277]: <-- [7:AT+FDT\r]
Aug 11 11:35:33.02: [15277]: --> [21:+FDCS:1,3,0,2,0,0,0,4]
Aug 11 11:35:33.02: [15277]: --> [7:CONNECT]
Aug 11 11:35:33.02: [15277]: SEND wait for XON
Aug 11 11:35:33.02: [15277]: --> [1:^Q]
Aug 11 11:35:33.02: [15277]: SEND begin page
Aug 11 11:35:33.02: [15277]: <-- data [1027]
Aug 11 11:35:33.02: [15277]: <-- data [1025]
Aug 11 11:35:33.02: [15277]: <-- data [1031]
Aug 11 11:35:33.02: [15277]: <-- data [1027]
Aug 11 11:35:33.02: [15277]: <-- data [1029]
Aug 11 11:35:33.21: [15277]: <-- data [1025]
Aug 11 11:35:33.21: [15277]: <-- data [1027]
Aug 11 11:35:33.26: [15277]: <-- data [1027]
Aug 11 11:35:35.79: [15277]: <-- data [1026]
Aug 11 11:35:37.47: [15277]: <-- data [1025]
Aug 11 11:35:38.68: [15277]: <-- data [1026]
Aug 11 11:35:39.59: [15277]: <-- data [1030]
Aug 11 11:35:40.54: [15277]: <-- data [1028]
Aug 11 11:35:41.47: [15277]: <-- data [1026]
Aug 11 11:35:42.42: [15277]: <-- data [1027]
Aug 11 11:35:43.34: [15277]: <-- data [1026]
Aug 11 11:35:44.98: [15277]: <-- data [1028]
Aug 11 11:35:45.95: [15277]: <-- data [1027]
Aug 11 11:35:46.96: [15277]: <-- data [1026]
Aug 11 11:35:47.95: [15277]: <-- data [1027]
Aug 11 11:35:49.32: [15277]: <-- data [1024]
Aug 11 11:35:50.16: [15277]: <-- data [1024]
Aug 11 11:35:51.00: [15277]: <-- data [1024]
Aug 11 11:35:51.86: [15277]: <-- data [912]
Aug 11 11:35:52.66: [15277]: SENT 24464 bytes of data
Aug 11 11:35:52.66: [15277]: <-- data [2]
Aug 11 11:35:52.66: [15277]: SEND end page
Aug 11 11:36:05.53: [15277]: --> [2:OK]
Aug 11 11:36:05.53: [15277]: SEND send EOP (no more pages or documents)
Aug 11 11:36:05.53: [15277]: <-- [9:AT+FET=2\r]
Aug 11 11:36:09.19: [15277]: --> [7:+FPTS:1]
Aug 11 11:36:10.37: [15277]: --> [7:+FHNG:0]
Aug 11 11:36:10.37: [15277]: REMOTE HANGUP: Normal and proper end of
connection (code 0)
Aug 11 11:36:10.37: [15277]: SEND recv MCF (message confirmation)
Aug 11 11:36:10.37: [15277]: SEND FAX (00000531): FROM nobody@mango TO
6718565 (page 1 of 1 sent in 0:43)
Aug 11 11:36:10.37: [15277]: SEND FAX (00000531): FROM nobody@mango TO
6718565 (docq/doc63.ps;01 sent in 0:43)
Aug 11 11:36:10.37: [15277]: <-- [5:ATH0\r]
Aug 11 11:36:11.41: [15277]: --> [2:OK]
Aug 11 11:36:11.41: [15277]: SESSION END


--
Best Regards,

Jeff @ Industrial House




____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null

Follow-Ups:
- Re: [hylafax-users] send fax small image problem
  - From: Lee Howard
- Re: [hylafax-users] send fax small image problem
  - From: Bernd Proissl

Prev by Date: [hylafax-users] Can hylafax+ADSL?
Next by Date: Re: [hylafax-users] send fax small image problem
Previous by thread: Re: [hylafax-users] Can hylafax+ADSL?
Next by thread: Re: [hylafax-users] send fax small image problem
Index(es):
- Main
- Thread

Report any problems to webmaster@hylafax.org

HylaFAX is a trademark of Silicon Graphics Corporation.
Internet connectivity for hylafax.org is provided by:
VirtuALL Private Host Services