Re: [hylafax-users] Setup Instructions

["Jeff Foster" <jfoster@bmcinteractive.com>]

Thank You so very much for your words of advice.  I was able to get my fax
server up with little more effort!!

Jeff
jfoster@bmcinteractive.com

-----Original Message-----
* Jeff Foster <jfoster@bmcinteractive.com> [20010125 00:30]: writing on the
subject '[hylafax-users] Setup Instructions'
Jeff> Hey~
Jeff> Can anyone point me to a good set of setup instructions.  I want to
set up a
Jeff> Multitech MT1932ZDX modem on a FreeBSD 4.1 OS using Hylafax-4.1beta2.
I've
Jeff> gone through the instructions at http://www.hylafax.org/setup.html &
tried
Jeff> to follow the Slackware Linux Installation at
Jeff> http://www.hylafax.org/howto/install.html#ss2.4 , but when it says to
edit
Jeff> the etc/setup.cache & /etc/inittab files as shown below, I cannot find
them

-----Reply-----
Wash> I run HylaFAX on 4.2-STABLE and those files are for Linux.
Wash> Once you've installed Hylafax and run faxaddmodem, you need to make
sure that:

Wash> o	You edit /etc/ttys to setup faxgetty to listen on a tty and you do
that by adding these lines.

Wash> #Necessary for HYLAFAX modem setup
Wash> cuaa0   "/usr/local/sbin/faxmodem"
Wash> cuaa0   "/usr/local/sbin/faxgetty"      dialup  on

Wash> If your modem is on COM2 , change cuaa0 to cuaa1

Wash> Next make sure HylaFAX is started at system startup time:

Wash> o	cd /usr/local/etc/rc.d
Wash> 	mv hylafax.sh.sample hylafax.sh
Wash> 	chmod +x hylafax.sh

Wash> Of course I am assuming that your config.cuaaX (where X=0,1 depending
on your COM port) is already
Wash> configured.

Wash> The rest that you see on that page is Linux-centric stuff.



____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null