|
Hylafax Mailing List Archives
|
[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index]
[Thread Index]
[hylafax-users] Partial and/or half page receipt of faxes
After bungling along I finally resolved this issue
by reducing the baud rate of the modem to 14400 in the config.ttyS1
file.
Here it is:
ModemType:
Class2 # use class 2
interface
ModemRate:
14400
ModemFlowControl:
rtscts #
default
#
ModemResetCmds:
AT&F1 # what you
want for a
Supra
ModemNoFlowCmd:
AT&K #
disable flow control
cmd
ModemHardFlowCmd:
AT&K3 # hardware
flow control cmd
ModemSoftFlowCmd:
AT&K4 # software
flow control cmd
ModemSetupDTRCmd:
AT&D3 # DTR off
causes modem to reset
#ModemSetupDTRCmd:
AT&D2S25=1S38=0 # Dynalink 1414VE needs
this
ModemSetupDCDCmd:
AT&C1 # DCD
follows carrier
#ModemSetupAACmd:
AT+FAA=1+FCLASS=0 # enable in current
class
ModemSetupAACmd:
AT+FAA=1
#
ModemSendFillOrder:
LSB2MSB # as
expected
ModemRecvFillOrder:
MSB2LSB # opposite of what makes
sense
#
ModemAnswerFaxBeginCmd: "<19200><xon>" # modem
switches on fax receive
#
Class2RecvDataTrigger: "\022
