[hylafax-users] "USE 2-DMR" based only on info/fax-no data?

[Giulio Orsero <giulioo@pobox.com>]

Linux Red Hat 61. HylaFAX cvs 20001022

- Fresh install (no files in info/ )
- Same doc sent twice to the same remote fax no.
- 1st time 1-D was used, 2nd time (info/fax-no says
supports2DEncoding:yes) 2-D.
- delete info/fax-no, fax, 1-D again

So it seems HylaFAX decides to use 2-D based on the info file and not on
what the remote fax says. Is this the intended behavior? Why? 

1st transmission, 1-D
[12575]: REMOTE best rate 14400 bit/s
[12575]: REMOTE max page width 2432 pixels in 303 mm
[12575]: REMOTE max unlimited page length
[12575]: REMOTE best vres 7.7 line/mm
[12575]: REMOTE best format 2-D MR    <=====
[12575]: REMOTE best 0 ms/scanline
[12575]: USE 14400 bit/s
[12575]: USE 0 ms/scanline
[12575]: SEND file "docq/doc1.ps;01"
[12575]: USE page width 1728 pixels in 215 mm
[12575]: USE unlimited page length
[12575]: USE 7.7 line/mm
[12575]: USE 1-D MR   <=====

2nd transmission, 2-D (info/fax-no says 
[12593]: REMOTE best rate 14400 bit/s
[12593]: REMOTE max page width 2432 pixels in 303 mm
[12593]: REMOTE max unlimited page length
[12593]: REMOTE best vres 7.7 line/mm
[12593]: REMOTE best format 2-D MR   <=====
[12593]: REMOTE best 0 ms/scanline
[12593]: USE 14400 bit/s
[12593]: USE 0 ms/scanline
[12593]: SEND file "docq/doc2.ps;41"
[12593]: USE page width 1728 pixels in 215 mm
[12593]: USE unlimited page length
[12593]: USE 7.7 line/mm
[12593]: USE 2-D MR     <=====


-- 
giulioo@pobox.com


____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null