[hylafax-users] factors in bad scan lines

To: hylafax-users@hylafax.org
Subject: [hylafax-users] factors in bad scan lines
From: Lee Howard <faxguy@deanox.com>
Date: Mon, 21 Aug 2000 22:06:24 -0600

I'm trying to work on a config file for a Supra 288i Sp modem.  This isn't
critical, I'm just trying to get a feel for general config file
customization.  Anyway, I've seen this before with various modems, and I
don't understand it.  It seems to be line noise, but it's not.  If I put a
USR/3Com modem on the same line I don't have any of these bad scan lines,
but the minute that this modem is there, I get lots of them.  I've noticed
that frequency of bad scan lines will vary from modem to modem in general
anyway.  I've used USR, Rockwell, Supra, and 3Com over the past months
(only to notice that I never have bad scan lines with the 3Com/USR,
occasional with Rockwell, and constant with Supra).  I'll be trying a few
more this coming week, too.  Anyway, my questions are:

What factors influence the receipt of bad scan lines?
Is this something that can be controlled or worked on by the config file?
Why does one modem not have problems, and another one does? firmware?

A typical yucky log follows:

Thanks.
Lee Howard


The full document was not received because:

    Normal and proper end of connection

    ---- Transcript of session follows ----
Aug 21 21:48:43.01: [ 1608]: SESSION BEGIN 00000021 14357550959
Aug 21 21:48:43.01: [ 1608]: <-- [4:ATA\r]
Aug 21 21:48:43.57: [ 1608]: --> [3:FAX]
Aug 21 21:48:43.57: [ 1608]: ANSWER: FAX CONNECTION
Aug 21 21:48:43.57: [ 1608]: RECV FAX: begin
Aug 21 21:48:49.30: [ 1608]: --> [5:+FCON]
Aug 21 21:48:50.95: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:48:50.95: [ 1608]: REMOTE TSI ""
Aug 21 21:48:51.36: [ 1608]: --> [22:+FDCS: 1,5,0,2,1,0,0,0]
Aug 21 21:48:51.36: [ 1608]: REMOTE wants 14400 bit/s
Aug 21 21:48:51.36: [ 1608]: REMOTE wants page width 1728 pixels in 215 mm
Aug 21 21:48:51.36: [ 1608]: REMOTE wants unlimited page length 
Aug 21 21:48:51.36: [ 1608]: REMOTE wants 7.7 line/mm
Aug 21 21:48:51.36: [ 1608]: REMOTE wants 2-D MR
Aug 21 21:48:51.36: [ 1608]: --> [2:OK]
Aug 21 21:48:51.36: [ 1608]: <-- [7:AT+FDR\r]
Aug 21 21:48:57.78: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:48:57.78: [ 1608]: REMOTE TSI ""
Aug 21 21:49:04.62: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:49:04.62: [ 1608]: REMOTE TSI ""
Aug 21 21:49:11.46: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:49:11.46: [ 1608]: REMOTE TSI ""
Aug 21 21:49:18.30: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:49:18.30: [ 1608]: REMOTE TSI ""
Aug 21 21:49:25.15: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:49:25.15: [ 1608]: REMOTE TSI ""
Aug 21 21:49:31.99: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:49:31.99: [ 1608]: REMOTE TSI ""
Aug 21 21:49:35.41: [ 1608]: --> [5:+FCFR]
Aug 21 21:49:37.99: [ 1608]: --> [22:+FDCS: 1,2,0,2,1,0,0,0]
Aug 21 21:49:37.99: [ 1608]: REMOTE wants 7200 bit/s
Aug 21 21:49:37.99: [ 1608]: REMOTE wants page width 1728 pixels in 215 mm
Aug 21 21:49:37.99: [ 1608]: REMOTE wants unlimited page length 
Aug 21 21:49:37.99: [ 1608]: REMOTE wants 7.7 line/mm
Aug 21 21:49:37.99: [ 1608]: REMOTE wants 2-D MR
Aug 21 21:49:37.99: [ 1608]: --> [7:CONNECT]
Aug 21 21:49:37.99: [ 1608]: RECV: begin page
Aug 21 21:49:37.99: [ 1608]: RECV: send trigger 022
Aug 21 21:49:37.99: [ 1608]: <-- data [1]
Aug 21 21:49:57.25: [ 1608]: RECV: 980 total lines, 649 bad lines, 186
consecutive bad lines
Aug 21 21:49:57.25: [ 1608]: --> [17:+FPTS: 1,2219,0,0]
Aug 21 21:49:58.47: [ 1608]: --> [7:+FET: 0]
Aug 21 21:49:58.47: [ 1608]: RECV recv MPS (more pages, same document)
Aug 21 21:49:58.58: [ 1608]: --> [2:OK]
Aug 21 21:49:58.58: [ 1608]: RECV: REJECT page quality, 33% good lines (95%
required)
Aug 21 21:49:58.58: [ 1608]: RECV send RTN (retrain negative)
Aug 21 21:49:58.58: [ 1608]: <-- [10:AT+FPTS=2\r]
Aug 21 21:49:58.83: [ 1608]: --> [2:OK]
Aug 21 21:49:58.83: [ 1608]: <-- [7:AT+FDR\r]
Aug 21 21:50:02.26: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:50:02.26: [ 1608]: REMOTE TSI ""
Aug 21 21:50:08.25: [ 1608]: --> [22:+FDCS: 1,2,0,2,1,0,0,0]
Aug 21 21:50:08.25: [ 1608]: REMOTE wants 7200 bit/s
Aug 21 21:50:08.25: [ 1608]: REMOTE wants page width 1728 pixels in 215 mm
Aug 21 21:50:08.25: [ 1608]: REMOTE wants unlimited page length 
Aug 21 21:50:08.25: [ 1608]: REMOTE wants 7.7 line/mm
Aug 21 21:50:08.25: [ 1608]: REMOTE wants 2-D MR
Aug 21 21:50:08.25: [ 1608]: --> [7:CONNECT]
Aug 21 21:50:08.25: [ 1608]: RECV: begin page
Aug 21 21:50:08.25: [ 1608]: RECV: send trigger 022
Aug 21 21:50:08.25: [ 1608]: <-- data [1]
Aug 21 21:51:20.82: [ 1608]: RECV: 605 total lines, 487 bad lines, 52
consecutive bad lines
Aug 21 21:51:20.82: [ 1608]: --> [17:+FPTS: 1,2219,0,0]
Aug 21 21:51:22.15: [ 1608]: --> [7:+FET: 0]
Aug 21 21:51:22.15: [ 1608]: RECV recv MPS (more pages, same document)
Aug 21 21:51:22.15: [ 1608]: --> [2:OK]
Aug 21 21:51:22.15: [ 1608]: RECV: REJECT page quality, 19% good lines (95%
required)
Aug 21 21:51:22.15: [ 1608]: RECV send RTN (retrain negative)
Aug 21 21:51:22.15: [ 1608]: <-- [10:AT+FPTS=2\r]
Aug 21 21:51:22.40: [ 1608]: --> [2:OK]
Aug 21 21:51:22.40: [ 1608]: <-- [7:AT+FDR\r]
Aug 21 21:51:25.87: [ 1608]: --> [29:+FTSI: "                    "]
Aug 21 21:51:25.87: [ 1608]: REMOTE TSI ""
Aug 21 21:51:31.87: [ 1608]: --> [22:+FDCS: 1,2,0,2,1,0,0,0]
Aug 21 21:51:31.87: [ 1608]: REMOTE wants 7200 bit/s
Aug 21 21:51:31.87: [ 1608]: REMOTE wants page width 1728 pixels in 215 mm
Aug 21 21:51:31.87: [ 1608]: REMOTE wants unlimited page length 
Aug 21 21:51:31.87: [ 1608]: REMOTE wants 7.7 line/mm
Aug 21 21:51:31.87: [ 1608]: REMOTE wants 2-D MR
Aug 21 21:51:31.87: [ 1608]: --> [7:CONNECT]
Aug 21 21:51:31.87: [ 1608]: RECV: begin page
Aug 21 21:51:31.87: [ 1608]: RECV: send trigger 022
Aug 21 21:51:31.87: [ 1608]: <-- data [1]
Aug 21 21:52:16.18: [ 1608]: RECV: 760 total lines, 600 bad lines, 108
consecutive bad lines
Aug 21 21:52:16.18: [ 1608]: --> [17:+FPTS: 1,2219,0,0]
Aug 21 21:52:17.40: [ 1608]: --> [7:+FET: 2]
Aug 21 21:52:17.40: [ 1608]: RECV recv EOP (no more pages or documents)
Aug 21 21:52:17.51: [ 1608]: --> [2:OK]
Aug 21 21:52:17.51: [ 1608]: RECV: REJECT page quality, 21% good lines (95%
required)
Aug 21 21:52:17.51: [ 1608]: RECV send RTN (retrain negative)
Aug 21 21:52:17.51: [ 1608]: <-- [10:AT+FPTS=2\r]
Aug 21 21:52:17.76: [ 1608]: --> [2:OK]
Aug 21 21:52:17.76: [ 1608]: <-- [7:AT+FDR\r]
Aug 21 21:52:20.65: [ 1608]: --> [8:+FHNG: 0]
Aug 21 21:52:20.65: [ 1608]: REMOTE HANGUP: Normal and proper end of
connection (code 0)
Aug 21 21:52:20.65: [ 1608]: RECV FAX (00000021): recvq/fax00019.tif from ,
route to <unspecified>, 0 pages in 3:37
Aug 21 21:52:20.65: [ 1608]: RECV FAX: Normal and proper end of connection
Aug 21 21:52:20.65: [ 1608]: RECV FAX (00000021): session with  terminated
abnormally: Normal and proper end of connection
Aug 21 21:52:20.65: [ 1608]: RECV FAX: bin/faxrcvd "recvq/fax00019.tif"
"ttyS0" "00000021" "Normal and proper end of connection"Content-Type:
image/tiff
Content-Description: FAX from  at






____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null

Follow-Ups:
- Re: [hylafax-users] factors in bad scan lines
  - From: "Jay R. Ashworth" <jra@baylink.com>
- Re: [hylafax-users] factors in bad scan lines
  - From: "Bernd Proissl" <news@proissl.de>

Prev by Date: Re: [hylafax-users] General Questions about Hylafax
Next by Date: Re: [hylafax-users] factors in bad scan lines
Prev by thread: Re: [hylafax-users] Fax Class 80 ?
Next by thread: Re: [hylafax-users] factors in bad scan lines
Index(es):
- Main
- Thread

Report any problems to webmaster@hylafax.org

HylaFAX is a trademark of Silicon Graphics Corporation.
Internet connectivity for hylafax.org is provided by:
VirtuALL Private Host Services