[hylafax-users] Re: Unspecified Phase D Errors w/ Comtrol Rocket

[wsuetholz@centonline.com]

I have a similar problem with this device..  Are you using the
ISA version or the PCI version?  My problems were seen with VSI-FAX
and the ISA version of the card.  I haven't actually tried these 
with HylaFAX.

So, let me know if you get a resolution to this problem..

Bill Suetholz

On 07-Jun-00 Mark Lehrer wrote:
> 
> Hello!  I have a comtrol rocketport 4-port card that is able to send
> faxes just fine.  However, when receiving faxes it gets 3-4 inches of
> the first page and then faxgetty exits with the following type of
> message:
> 
> Jun  7 10:06:11 penguin FaxGetty[4789]: MODEM ROCKWELL
> AC/V34/V2.200G-V34_ACF_DS1
> Jun  7 10:06:18 penguin FaxGetty[4789]: ANSWER: FAX CONNECTION
> Jun  7 10:07:12 penguin FaxGetty[4789]: RECV FAX (00000039): from 801
> 268 2772, page 1 in 0:41, INF, 7.7 line/mm, 1-D MR
> Jun  7 10:07:19 penguin FaxGetty[4789]: RECV FAX (00000039):
> recvq/fax00017.tif from 801 268 2772, route to <unspecified>, 1 pages in
> 1:01
> Jun  7 10:07:19 penguin FaxGetty[4789]: RECV FAX (00000039): session
> with 801 268 2772 terminated abnormally: Unspecified Phase D error
> Jun  7 10:07:19 penguin FaxGetty[4789]: RECV FAX: bin/faxrcvd
> "recvq/fax00017.tif" "ttyR0" "00000039" "Unspecified Phase D error"
> 
> 
> Any ideas on what I can do to make this work?
> 
> Thanks!
> Mark Lehrer
> 


____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null