FW: flexfax: "Waiting for modem to come ready!" with more than two modems!!

["Ken Cornetet" <kcornet@kimball.com>]

Even if his kernel supports IRQ sharing, no ISA serial port board that I've
ever seen supports IRQ sharing between different boards. There are serial
boards that multiplex many ports on one IRQ, but none that allow multiple
boards to share IRQs.

Ulrich, if you want 4 "dumb" (16550 UART type) serial ports, you are going
to have to assign each it's own interrupt. You didn't mention what type of
serial port hardware you are using, but it sounds like you have a couple of
standard two port boards, or perhaps two ports on the motherboard, and a two
port card.

If that is the case, you may be out of luck. Many (most?) two port serial
boards only allow for IRQ 3 or 4. If that is the only choices for both
cards, you can't use them together. Otherwise, try jumpering your COM3 and
COM4 (0x3e8 and 0x2e8) to IRQs 5 and 9. You will have to use the "setserial"
command to tell the serial port drivers which IRQs the ports are using.

You may want to investigate an intelligent serial IO board such as a
RocketPort. You can get several (8 or 16) ports on one IRQ.

One bit of warning: I've never tried *any* intelligent serial board on a
linux system, but I have tried them on an older Intel based unix system. The
intelligent IO boards just never seemed to have the bugs worked out.

-----Original Message-----
From: owner-flexfax@celestial.com [mailto:owner-flexfax@celestial.com]
On Behalf Of Ulrich Eckhardt
Sent: Wednesday, March 10, 1999 2:53 AM
To: flexfax@sgi.com
Subject: Re: flexfax: "Waiting for modem to come ready!" with more than
two modems!!


Hi,

what kernel version do you have ? The 2.0.36 does not support
irq sharing. Therefore you need kernel 2.2.3 .

Can  you access the modems e.g. via minicom ?

Uli

Dietmar Osterburg wrote:
>
> Hallo there,
>
> I use Hylafax Version  v4.0pl2 on an Intel-machine (i386) with  SuSE
> Linux 6.0
>
> I want to run Hylafax with 4 modems, but only two are actuell running
> !
> The faxstat command tells me:   2 are running and idle!
>                                                 2 are toggling
> [waiting for modem come ready -> Initializing server -> .....]
> In /etc/inittab the four entrys are available:
[..]
> ** Each modem runs fine when I enter ONLY two faxgetty lines  in
> inittab. **
>
> Each modem has its own serial port  (Port:2f8, Int:3     Port:3f8,
> Int:4     Port:2e8, Int:3,      Port:3e8, Int 4 ).
> Each Serial-Interrupt is shared by 2 Modems - this ( I think ) can be
> perhaps the problem.


--
Ulrich Eckhardt                         Tr@nscom GbR
http://people.frankfurt.netsurf.de/uli  http://www.transcom.de
                                        Lagerstraße 11-15 A8
                                        64807 Dieburg Germany