flexfax: Configuration issues for Class 1 modems, and the new security patches

[Nico Kadel-Garcia <raoul@cirl.meei.harvard.edu>]

-----BEGIN PGP SIGNED MESSAGE-----


After having worked out the necessary tweaks to get a cheap Performa
33.6 modem to handle data calls, I'd like to embed those tweaks in an
appropriate configuration file. Unfortunately, the parsing of the
files by faxaddmodem is a bit confusing and obscure to me.  Probemodem
reports the following.

ATI0	RESULT = "OK"	RESPONSE = "33600"
ATI3	RESULT = "OK"	RESPONSE = "V2.061.2-V34_ACF_DS1"

What is the correct "CONFIG" or other lines to get a Class 1 modem
selected in $SPOOLDIR/config file, rather than the generic class 1
file?

Also: the new security patches for faxsetup, recvstats, probemodem,
etc. use the "noclobber" shell option. This option is unfortunately a
*BASH* option, and is not available under the older SunOS shell. I'm
not quite sure what to do about that....

			Nico Kadel-Garcia
			Senior Engineer, CIRL 
			Mass. Eye and Ear Infirmary
			raoul@cirl.meei.harvard.edu

-----BEGIN PGP SIGNATURE-----
Version: 2.6.2

iQCVAwUBNkyxTT/+ItycgIJRAQG8agP+MU9fUDoqtZL2g0iEA8h3pqsKSFPO0woT
85qNs2M1LlcHblbxvyQazty/ziu1n2W++oPFxHC32UYshf/i8SziBKlLoMRI17ku
zaTW+EMMw1osbB9siiW5CDW2y/IEw5oyrIDv/kIWuDhRPlMgsIGoEqu0TEPAD04k
rKH3cR+zou0=
=2vS4
-----END PGP SIGNATURE-----